Bedienungsanleitung Robomow RC308u (Seite 23 von 58) (Englisch)

664045

Zoom out

Zoom in

Vorherige Seite

1/58

Nächste Seite

4.3.4 Using Sub-Zones as Remote Starting Points

There are cases when a Main Zone has two or more big parts connected by a wide (more than 2 meters) passage,

like a front and a back yards.

In order to ensure proper coverage of all Main Zone’s parts in such cases, you may want the mower to occasionally

startmowingatsomespecicpoint(otherthantheBaseStation)alongtheperimeterwire.Wecallthesepoints

–RemoteStartingPoints.SettingaRemoteStartingPointcanbedonebydening(adding)aSub-Zoneatthe

desired place (see section 6.4.2, P022-P023).

Note:

DuringtheSub-Zonedenitionprocessyouareaskedtospecifytheareaofanewlyaddedsub-zone.Incaseof

a Remote Starting Point, this area should be the area of the remote part of the Main Zone. You need to reduce

MainZone’sareasettingaccordingly(seesection6.4.1).Seetheexamplebelow.Thisprocessactuallydenes

the probability (or the frequency) of departures from each starting point (when for the Main Zone the Base Station

itself is a starting point).

Example:

Let’s say your Main Zone is 1000m

. It

has a back yard (400m2), where the

Base Station is installed, and a front yard

(600m2). In order to dene a Remote

Starting point for the front yard, start a

process of adding a Sub-Zone. Once

well inside the front yard, set the area of

the newly added Sub-Zone to 600 and

immediately reduce (see section 6.4.1)

the area of the Main Zone to 400m2.

Thus, we now have 40% probability for

the mower to start from the Base Station

to cover the back yard, 60% probability

to start from the Remote Starting point in

favor of the front yard, as demonstrated

in the following drawing:

4.4 Fastening Perimeter Wire to the

Ground

o Before starting to lay the Perimeter Wire, it is recommended to cut the grass where the wire is to be laid.

It will then be easier to attach the wire to the ground. The risk that the mower will damage the wire during

the operation is reduced.

o It is not necessary to bury the Perimeter Wire, though you may do so, up to 5 cm (2 inches) deep.

o Pull the wire tight while hammering the peg all the way into the ground.

o Considerburyingthewireatexposedareas,suchaspavementsorotherareaswithafrequentfoottrafc.

WARNING !

Protect your eyes! Protect your hands!

Use proper eye protection and wear appropriate work gloves when hammering the pegs.

Hard or dry ground may cause pegs to break when driving them in.

o Use a hammer to insert the pegs into the ground.

o Insert the pegs at distances that will keep the wire

down below the grass level and prevent the wire from

becoming a tripping hazard (approximately 75 cm /

30” between pegs).

• The wire and the pegs will gradually become

invisible under the growth of new grass.

Remote Starting Point

Main Zone

At least 2 meters (6.5 ft.)

wide

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Robomow RC308u Seite 23

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Robomow RC308u

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info