Bedienungsanleitung Robomow RC308u (Seite 49 von 58) (Englisch)

664045

Zoom out

Zoom in

Vorherige Seite

1/58

Nächste Seite

Problem

Encountered

Probable Cause/Event Correcve Acons

Mower does not

dock properly

and sometimes

misses the Base

Station contacts

- Height differences between the lawn and

the Base Station surface.

- FillsomegroundtoattenthelawntotheBase

Station to allow smooth entrance.

- The wire underneath the Base Station is

not tight and placed in the middle of the

Station.

- ConrmthewireunderneaththeBaseStation

is straight, tight, and centered below the Base

Station.

- The Base Station is set up on a side

slope.

- Move the Base Station to a relatively level

ground.

- The Base Station is placed too close to

the corner of the lawn

- Move the Base Station so it is not within 3

meters after a corner.

Uneven mowing

results

- The time between operations is too long

because of long inactive time windows.

- Minimize the Inactive Time windows to allow

Robomow to complete the Mowing Cycle faster

and to achieve even mowing results.

- Grass is growing very fast.

- If it is during a fast growing season – change

the Mowing Frequency (refer to Section 6.4.2 –

P001).

- The shape of the lawn is complicated

(Narrow Passages, obstacle and islands).

- In a complicated lawn more time is required for

the mower to achieve better mowing results.

- Increase the mowing hours percentage (refer to

Section 6.4.1.2).

- The set area is smaller than the actual

lawn size.

- Increase the zone area (refer to Section 6.4.1.4)

Robomow

operates during

Inactive Time.

- Wrong clock time is set in the mower.

- Verify that the time on the mower is set correctly.

- Set the time (refer to Section 6.4.1.1).

- Reset the Inactive Time (refer to Section

6.4.1.3).

Robomow

operates during

rain

- Rain Sensor is disabled or its sensitivity

is set too low

- Enable the Rain Sensor and adjust its sensitivity

if required (refer to Section 6.4.2 – P007/p008)

- The Islands feature is set to On. In this

case the mower is searching for the base

by moving around the lawn. This special

search method takes more time, and

may create an impression that the mower

is still mowing, while in fact it is already

searching for the Base Station.

- No special action is required. For more

information about the Islands On/Off feature

refer to Section 6.4.2 – P002)

Cut wire indicator

isashingon

Power Box

- The Extension Cable is disconnected or

damaged between Power Box and the

Base Station.

- ConrmtheExtensionCableispluggedinand

wireleadsarermlyattached.

- Perimeter Wire is cut.

- Walk along Perimeter Wire.

- Look for cuts or breaks in the wire.

- Repair with Robomow wire splice connectors.

- Scan the code and

watch the video

demonstrating the

Corrective Actions of

the “Perimeter Wire

is cut”.

The poor

connection

indicator is

ashingon

Power Box

- Poor connections

- Check and repair all loose, poor, or corroded

connections.

- Twisted cables or a screw terminal which

is insulated with insulation tape is not a

satisfactory splice.

- Soil moisture causes the conductors to

oxidize.

- Use the connectors supplied in the box. They

are waterproof and give a reliable electrical

connection.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Robomow RC308u Seite 49

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Robomow RC308u

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info