Bedienungsanleitung Robomow RM200 (Seite 15 von 44) (Englisch)

512474

Zoom out

Zoom in

Vorherige Seite

1/44

Nächste Seite

1.3.2 Laying Out the Perimeter Wire

 Start setting the perimeter wire by placing pegs every few meters and at the lawn corners according to

your plan; do not forget obstacles that need to be demarcated while laying the wire.

 After removing enough wire within a given section, use the RoboRuler provided to set the correct distance

from the lawn edge. The RoboRuler is used to help position the perimeter wire along walls, fences,

sidewalk, driveways, flowerbeds and other perimeter zones.

There are two basic measurements that are used on the RoboRuler (Figure 1.12).

The shorter distance is used along perimeter edges where the area outside the immediate perimeter is

free of obstacles and is the same relative height as the perimeter edge or lower (sidewalk on the same

level or flowerbeds).

The longer distance is used along perimeter edges where the area outside the immediate perimeter has

obstacles or differences in the height along the perimeter edge (walls and fences).

Important

If the lawn's edge borders with a pond, swimming pool or watercourse or where the grass level is higher

than 70cm (2ft) from the edge around it, then it is required to keep a distance of at least 1.2m (4ft)

between the wire and the water (or chasm) otherwise supplement a fence or the same along the lawn's

edge, so Robomow can detect it. The height must then be at least 15cm (6 inch). This will prevent

Robomow, under any circumstances, from crossing the wire outside the working area

1.3.3 Fastening The Wire To The Ground

 It is not necessary to bury the perimeter wire, though you may do so if you wish, up to 10 cm

(4 inches) deep.

 Small pegs or stakes are supplied with the Robomow and they are used to fasten and hold the

perimeter wire to the ground, below grass level.

 Initially place a minimum number of pegs to fasten the wire down. Remember that you will want to test

the wire set up before you fill in additional pegs and you may find some areas where you will need to

move the wire position slightly.

 Upon hammering the peg to its final depth in the ground, pull the wire tight. It is a lot easier to insert

pegs into wet soil. If the soil is dry, water the yard before perimeter wire set up.

WARNING!

Damage to the eye is possible. Use proper eye protection and wear

appropriate work gloves when hammering the pegs. Hard or dry ground

may cause pegs to break when driving them in. In extreme cases,

watering the lawn where the pegs will be driven can be beneficial.

Short distance of RoboRuler

– where the area outside

the immediate perimeter is

free of obstacles and is the

same relative height as the

perimeter edge or lower

Long distance of

RoboRuler – where

the area outside the

immediate perimeter

has obstacles or

differences in the

height along the

erimeter ed

Figure 1.12 – using the RoboRuler

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Robomow RM200 Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Robomow RM200

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info