512474
35
Zoom out
Zoom in
Vorherige Seite
1/44
Nächste Seite
35
Wire
Connector
1
2
3
Wire
Connector
11
22
33
Figure 5.2
Wires splicing
1. Strip one cm (0.5 inch) of
each wire ends together
and twist the stripped ends
together using pliers.
2. Insert the twisted wires into
the splicing connector.
3. Screw the wire connector
on the twisted wires; make
sure is tight.
Figure 5.3
Charging
5.5 Splicing the Perimeter Wire
If the perimeter wire needs to be spliced: Use the connectors supplied in the box, as shown in figure 5.2. It is
waterproof and gives a reliable electrical connection.
IMPORTANT INFORMATION!
Twisted cables, or a screw terminal, insulated with insulation tape is not a satisfactory splice. Soil
moisture will cause the conductors to oxidize and after a while result in broken circuit.
5.6 Winter Storage
Robomow
Remove the battery fuse and clean the Robomow (refer to sections 5.2). Store Robomow indoors in a clean
a dry place, standing on its wheels; confirm the area around the bumper is free.
Insert the battery fuse and connect the power Supply to the mains supply (figure 5.3)
for the entire period
in which Robomow will not be operating; confirm ‘Charging’ is displayed and ‘Ready – keep charging’
when the battery is fully charged.
The charging system and battery are designed such that they can remain plugged in at all times of non-use
without concern to over charging, over heating or damaging the battery.
Perimeter Switch
It is recommended to remove the
Perimeter Switch for the winter period:
- Disconnect the power supply from the mains power;
- Open the Perimeter Switch cover;
- Disconnect all connectors from the board;
- Remove the Perimeter Switch and place it in dry storage;
- Disconnect the green plot connector (keep it connected on the board for the next season) from the
perimeter wire ends and protect it from moisture to prevent corrosion of the wires while not connected to
the Perimeter Switch; You may place the Friendly Robotics wire nut connector onto both wire ends for
protection in the winter.
35

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Robomow RM200 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Robomow RM200

Robomow RM200 Bedienungsanleitung - Deutsch - 44 seiten

Robomow RM200 Bedienungsanleitung - Holländisch - 44 seiten

Robomow RM200 Bedienungsanleitung - Französisch - 61 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info