If you do have Sub-Zone(s):
3.3.9 Going to Sub-Zone 1
Robomow will follow the Perimeter Wire around the edge
towards the Sub-Zone.
3.3.10 Press STOP at Zone Entry
P When Robomow is at least 5 m (16 ft.) inside that Sub-Zone –
Press Stop so Robomow will learn the distance from the Base
Station to Sub-Zone Entry.
If you don’t have an additional Sub-Zone:
P Choose the
mark and press .
If you do have another Sub-Zone(s):
P Choose the
mark and repeat the Sub-Zone procedure
(See Section 3.3.8).
3.4 After Setup is Complete
Once the wire setup is complete, you can drive additional pegs at a
distance of approximately 1 m (3.3 ft.) between them.
P Use additional pegs in areas where there are bumps or dips in
the lawn.
If needed, purchase extra pegs.
P Inspect the wire installation for tripping hazards.
From this point on Robomow is ready to be charged.
Once fully charged it will automatically mow your lawn.
Please note! The initial charging may take longer then
usual (up to 24 hours).
