Message
Displayed
Probable Cause/Event Corrective/User Action
Cross Outside
- The Perimeter Wire is too close to the edge.
- The lawn slope is too big.
- Robomow does not succeed to turn in place at
the edge and it causes the mower to slip out of
the area.
- Robomow has slipped out of the Perimeter
Wire loop because of a sloping area or wet
grass.
- Move the wire towards the inner side of the lawn.
- Do not include area with very steep slopes.
- Fill holes and pits in the ground.
- Increase the cutting height.
Drive Overheat
Cooling…
- The drive motors have been working under a
severe load for too long.
- No need to do anything.
- Robomow will renew the operation automatically as
soon as the drive motor will cool down.
Front Wheel
Problem
- The Front Wheel has left the ground for too
long time during operation.
- If Robomow has driven onto an obstacle, raising the
front end:
Remove or exclude the object from the mowing area.
- If Robomow is being used on a slope too steep for safe
mowing:
Exclude this from the mowing area.
- If High grass is preventing the front wheel from fully
riding on the ground:
Raise the cutting height.
- If the ground contains large holes or indentations where
the front wheel can drop into when passing across:
Fill these areas with dirt and level off.
Handle Lifted
- The handle is lifted while trying to start the
operation
- Push the carrying handle down back to its position to
enable automatic operation.
Key Pressed
- One of the operating panel buttons is
constantly pressed.
- Press
to confirm the message and to continue
operation. This message is displayed to inform only.
Keys Locked
- Child Lock feature has been activated.
- Press the
button and then press the
button.
Child Lock can be deactivated under the Settings
menu.
Mow Overheat
cooling…
- The mowing motor has been working under a
severe load for too long of a time.
- No need for action – Robomow will renew automatically
the operation, as the mowing motor will cool down.
No wire signal
- Power Box / Perimeter Switch is not turned on
or not connected to the zone intended to mow.
- Power Box may need to be restarted
- The Perimeter Wire is not connected to the
Base Station / Perimeter Switch.
- The Perimeter Wire is cut.
- Make sure the Base Station is connected to the mains
supply.
- Disconnect the Power Box from the mains power and
reconnect after 10 seconds.
- Check the Perimeter Switch is connected to the correct
zone and is turned on.
- Check the connection of the Perimeter Wire to the Base
Station / Perimeter Switch.
- Check for cut in the Perimeter Wire.
Rain detected
- The operation is delayed as Robomow detects
rain.
- Robomow should resume operation 30 minutes
after it stops to detect the rain.
- No need for action
- The message is displayed as long as rain/humid
conditions are detected by Robomow. Mowing will
restart automatically.
Raise Mowing
Height
- TurboMow mode has been activated.
- It is recommended to raise mowing height before
starting the mower in TurboMow mode. Refer to sections
3.1 and 4.3.7 in the User Manual.
