512483
44
Zoom out
Zoom in
Vorherige Seite
1/54
Nächste Seite
34
Robomow RS models
Chapter 7 Troubleshooting
7.1 Text error-messages
Robomow continuously monitors its operation. It produces text messages to assist you in smoothly running it: text
messages in case of an operational fault as well as text messages that prompt the user to perform a certain action.
Usually, if the mower stops, a message is displayed. This display stays on for 15 minutes.
If you arrive later than those 15 minutes, the display will be blank.
To wake Robomow up and see the last text message displayed prior to stopping, press
.
The following table displays all fault message displays and their most common causes. The next table will give details
and possible causes of other faults, that do not provide fault messages.
If a fault cannot be dealt with using these tables, please call your service provider.
7.2 Error Messages And Corrective Actions
The list is alphabetical, by message text
Message
Displayed
Probable Cause/Event Corrective/User Action
Base Problem
- Robomow fails to enter the Base Station
several times continuously.
- Adjust the Base Station position.
- Clean the contacts with a brush or piece of cloth.
Bumper Pressed
- Bumper is constantly being pressed.
- Move mower away from object that presses against the
bumper.
Check Mow
Height
- Mowing motor has faced over-current for too
long as a result of high grass or an obstacle
that is stuck or wrapped around the blade.
- Something is preventing a blade from rotating
freely. Severe grass accumulation under the
mowing deck; rope or similar object wrapped
around mowing blade.
- CAUTION – Switch off the Safety Switch before
checking the blades.
- Inspect blades for foreign material or debris preventing
rotation.
- Clean out accumulated grass clippings using a wooden
stick.
Check Power
- Power Box is not plugged properly into the
main Power Box.
- Confirm Power Box is plugged into the main power plug
socket.
- No power to plug socket or main power is shut
off.
- Turn power on to the main plug socket.
- Check the mains supply using another appliance.
- The mower or Charging Station contacts are
dirty.
- Clean the contacts with a brush or piece of cloth.
- Charging is not detected, although there is
physical contact between the mower and the
Base Station contacts.
- Confirm a good connection of the Power Box to the
Base Station.
44

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

robomow-rs630

Suche zurücksetzen

  • Hallo. Ich habe den robomow rs 630 zeigt 44 bestätigt. Komme nicht ins Display. Ladet nicht auf. Eingereicht am 6-9-2022 12:09

    Antworten Frage melden
  • Robomow RS 630 Im Display keine Anzeige nach 1. inbetriebnahme Eingereicht am 20-4-2020 08:58

    Antworten Frage melden
  • im Display anzeige erscheint bereit und abbildung kabelstecker. es erfolgt kein funktion Eingereicht am 16-6-2018 06:55

    Antworten Frage melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Robomow RS630 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Robomow RS630

Robomow RS630 Bedienungsanleitung - Deutsch - 54 seiten

Robomow RS630 Bedienungsanleitung - Holländisch - 54 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info