Bedienungsanleitung Robomow Tuscania 500 (Seite 66 von 268) (Deutsch, Englisch, Holländisch, Französisch, Italienisch)

512484

Zoom out

Zoom in

Vorherige Seite

1/268

Nächste Seite

 Note: The power supply is suitable for outdoor use, yet it is required placing it in a sheltered

place, dry location, which is well ventilated and not exposed to direct sunlight.

Place the Base Station at least one-meter from corners;

 Position the Base Station with its fence facing to the inside of the lawn;

 Robomow is impervious to water and rain, however it is recommended to place the Base Station

away from sprinkler heads for maximum protection.

1.2.2 Multiple Zones/Areas

Your home may require more than one zone to be set up in order for the Robomow to work in all of your lawn

effectively. Where grass areas are not contiguous, or are separated by fences, sidewalks or other objects, it is

required to make each of these a separate zone.

When setting separated zones there are two options to lay the wire:

Option A

: All zones are looped together and connected to the Base Station. If the distance between two adjacent

wires is greater than one meter, you can include it in the main loop connected to the Base Station as Robomow

can effectively navigate through in order to move between the two areas while mowing the lawn, otherwise it is

required to separate the area into two different zones.

Perimeter wire can be as long as 500 meters (1650ft) in one loop when connected to the Base Station (Figure 1.4).

Option B

: There are separated zones (Figure 1.5) that connected to the Base Station and the Perimeter Switch

(available as an accessory- see Chapter 7).

To mow other areas, simply drive or carry Robomow to the area you want to mow and operate it. In this way, if

one zone needs a shorter operating time than another, it can easily be set (Chapter 2.1.2). When this area is

completed, drive the mower back to the station for re-charging.

Determining the distance between adjacent perimeter wires:

1. If lawns are installed by the same perimeter wire that is connected to the same source (Base Station /

Perimeter Switch), then it is enough to keep a distance of one meter between the wires to prevent

interference in operation.

2. If lawns are installed using different perimeter wires that are not connected, and each has its own source

(Base Station / Perimeter Switch), then one of the following is required:

a. Maintain a minimum distance between the wires (30-50cm) to allow overlap between mowing zones,

but synchronize between the mowing schedules to confirm there will not be interference between the

zones. OR

b. Keep two meters between the perimeter wires with no need to synchronize between the operation

schedules.

WARNING!

Serious Injury Can Occur! When placing the power cord

leading to the Base Station, insure it is fastened securely to

the ground and does not present a tripping hazard.

Do not cross over surfaces such as sidewalks and

driveways where it cannot be fastened securely.

Figure 1.3 -

Base Station distance from wall socket

The Fence

should be

inside lawn

Min 1m (3ft)

from a corner

Max 15m (50ft)

Low voltage

cable

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Robomow Tuscania 500 Seite 66

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info