Bedienungsanleitung Rodania 25049 - ETA 2824-2 (Seite 2 von 2) (Englisch)

587119

Zoom out

Zoom in

Vorherige Seite

1/2

Nächste Seite

www.rodania.com

The scheme below shows the correct interpretation of the different case back inscriptions on your watch.

Case back engraving:

• 3 ATM: the watch resists to accidental contact with water and normal perspiration.

It means no immersion in water, neither for swimming nor aquatic sports.

• WATER RESISTANT 5 ATM: this watch resists to occasional immersion.

An annual control of the sealing gaskets is necessary.

• WATER RESISTANT 10 ATM: the watch is suited for all aquatic sports, except diving.

An annual control of the sealing gaskets is necessary.

• WATER RESISTANT 20 ATM: the screwed crown, the thickness of the crystal and packings have been especially

designed to withstand pressure of 20 atm. Make sure that the crown is entirely screwed, before you go into the water.

An annual control of the sealing gaskets is necessary.

3 ATM

5 ATM

10 ATM

20 ATM

Case back engraving

www.rodania.com

INSTRUCTIONS FOR MECHANICAL WATCHES

IMPORTANT INFORMATION

Before wearing or after an extended period of non-use, the movement must be set in motion by winding the crown

clockwise in its normal position.

After each operation, you must always push the crown back down to ensure that your watch remains water-resistant.

VALJOUX 7750

Display and functions

1 Hour hand

2 Minute hand

3 Small second hand

4 Date display

5 Day display

Chronograph

6 Central 60-second counter hand

7 30 minute counter hand

8 12 hour counter hand

9 Tachometric scale (depending on model)

10 Stop/Start push button for timing/chronograph functions

11 Reset push button on counters

www.rodania.com

ETA 2824-2

Winding

Crown in position I, not pulled out.

Manual winding is necessary if you have not been wearing your watch for a considerable period of time. To restart it, you

only need to turn the crown a few times (clockwise), or tilt your watch from side to side a few times. To restore the power

reserve of your watch to more than 42 hours, you need to turn the crown 20 to 25 times (clockwise).

Whenever you wear your watch, the automatic mechanism is wound every time you move your wrist.

Display and functions

1 Second hand

2 Minute hand

3 Hour hand

4 Date display*

5 Day display*

* depending on model

www.rodania.com

Setting the time

Pull the crown into position III; the second hand (1) stops at this point. Turn the crown clockwise or anticlockwise until

your watch displays the correct time. Whenever the hours hand passes the 12-o’clock position, you will see whether it is

displaying midnight (the date changes) or midday (the date does not change).

Setting the date*

Important: do not set the date* between 10 pm and 2 am (the movement is in the process of changing the date. This will

seriously damage the movement, and such damage is not covered under the Rodania warranty.

Pull the crown into position II and turn it clockwise to adjust the date (4). During this operation, your watch continues to

function normally so there is no need to correct the time afterwards.

* Depending on model

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Rodania 25049 - ETA 2824-2 Seite 2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Rodania 25049 - ETA 2824-2

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info