Bedienungsanleitung Roland C-200 (Seite 6 von 52) (Englisch)

527425

Zoom out

Zoom in

Vorherige Seite

1/52

Nächste Seite

IMPORTANT NOTES

In addition to the items listed under “USING THE UNIT SAFELY” on p. 4, please read and observe the following:

Power Supply

• Do not connect this unit to same electrical outlet that is being

used by an electrical appliance that is controlled by an

inverter (such as a refrigerator, washing machine, microwave

oven, or air conditioner), or that contains a motor. Depending

on the way in which the electrical appliance is used, power

supply noise may cause this unit to malfunction or may

produce audible noise. If it is not practical to use a separate

electrical outlet, connect a power supply noise filter between

this unit and the electrical outlet.

• The AC adaptor will begin to generate heat after long hours

of consecutive use. This is normal, and is not a cause for

concern.

• Before connecting this unit to other devices, turn off the

power to all units. This will help prevent malfunctions and/

or damage to speakers or other devices.

Placement

• Using the unit near power amplifiers (or other equipment

containing large power transformers) may induce hum. To

alleviate the problem, change the orientation of this unit; or

move it farther away from the source of interference.

• This device may interfere with radio and television reception.

Do not use this device in the vicinity of such receivers.

• Noise may be produced if wireless communications devices,

such as cell phones, are operated in the vicinity of this unit.

Such noise could occur when receiving or initiating a call, or

while conversing. Should you experience such problems, you

should relocate such wireless devices so they are at a greater

distance from this unit, or switch them off.

• Do not expose the unit to direct sunlight, place it near devices

that radiate heat, leave it inside an enclosed vehicle, or

otherwise subject it to temperature extremes. Also, do not

allow lighting devices that normally are used while their light

source is very close to the unit (such as a piano light), or

powerful spotlights to shine upon the same area of the unit

for extended periods of time. Excessive heat can deform or

discolor the unit.

• When moved from one location to another where the temper-

ature and/or humidity is very different, water droplets

(condensation) may form inside the unit. Damage or

malfunction may result if you attempt to use the unit in this

condition. Therefore, before using the unit, you must allow it

to stand for several hours, until the condensation has

completely evaporated.

• Do not allow rubber, vinyl, or similar materials to remain on

the unit for long periods of time. Such objects can discolor or

otherwise harmfully affect the finish.

• Do not allow objects to remain on top of the keyboard. This

can be the cause of malfunction, such as keys ceasing to

produce sound.

• Do not paste stickers, decals, or the like to this instrument.

Peeling such matter off the instrument may damage the

exterior finish.

• Depending on the material and temperature of the surface on

which you place the unit, its rubber feet may discolor or mar

the surface. You can place a piece of felt or cloth under the

rubber feet to prevent this from happening. If you do so,

please make sure that the unit will not slip or move acciden-

tally.

• Do not put anything that contains water (e.g., flower vases)

on this unit. Also, avoid the use of insecticides, perfumes,

alcohol, nail polish, spray cans, etc., near the unit. Swiftly

wipe away any liquid that spills on the unit using a dry, soft

cloth.

Maintenance

• To clean the unit, use a dry, soft cloth; or one that is slightly

dampened. Try to wipe the entire surface using an equal

amount of strength, moving the cloth along with the grain of

the wood. Rubbing too hard in the same area can damage the

finish.

• Never use benzine, thinners, alcohol or solvents of any kind,

to avoid the possibility of discoloration and/or deformation.

Additional Precautions

• Unfortunately, it may be impossible to restore the contents of

data that was stored on a USB storage device once it has been

lost. Roland Europe assumes no liability concerning such loss

of data.

• Use a reasonable amount of care when using the unit’s

buttons, sliders, or other controls; and when using its jacks

and connectors. Rough handling can lead to malfunctions.

• When connecting / disconnecting all cables, grasp the

connector itself—never pull on the cable. This way you will

avoid causing shorts, or damage to the cable’s internal

elements.

• To avoid disturbing your neighbors, try to keep the unit’s

volume at reasonable levels. You may prefer to use

headphones, so you do not need to be concerned about those

around you (especially when it is late at night).

• When you need to transport the unit, package it in the box

(including padding) that it came in, if possible. Otherwise,

you will need to use equivalent packaging materials.

• Do not apply undue force to the music stand while it is in use.

• Use only the specified expression pedal (EV-7 or EV-5; sold

separately). By connecting any other expression pedals, you

risk causing malfunction and/or damage to the unit.

Using USB Memory

• When connecting USB memory, firmly insert it all the way

into the USB memory port.

• Do not touch the pins of the USB memory port, or allow them

to become dirty.

• USB memory is made using high-precision electronic compo-

nents, so please observe the following points when handling

it.

• To prevent damage from static electrical charges,

discharge any static electricity that might be present in

your body before handling USB memory.

• Do not touch the terminals with your fingers or any metal

object.

• Do not bend or drop USB memory, or subject it to strong

impact.

• Do not leave USB memory in direct sunlight or in

locations such as a closed-up automobile. (Storage

temperature: 0~50°C)

• Do not allow USB memory to become wet.

• Do not disassemble or modify USB memory.

• When connecting USB memory, position it horizontally with

the C-200’s USB Memory port and insert it without using

excessive force. The USB memory connector may be damaged

if you use excessive force when inserting USB memory.

C-200_e.book Page 6 Monday, April 4, 2011 5:22 PM

Roland C-200 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Roland C-200

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info