Bedienungsanleitung Roland CUBE STREET (Seite 8 von 44) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch)

527777

Zoom out

Zoom in

Vorherige Seite

1/44

Nächste Seite

Panel descriptions

18.

POWER Switch

This switches the power on and off.

* This unit is equipped with a protection circuit. A brief interval

(a few seconds) after power up is required before the unit will

operate normally.

* If you need to turn off the power completely, first turn off the

POWER switch, then unplug the power cord from the power

outlet. Refer to “Power Supply: Use of Batteries” (p. 4).

19.

AUX IN Jack

You can connect a CD player, MP3 player or other kind of

device and have it play along with your guitar or other kind

of devices. This accepts a stereo miniature phone plug.

* Determine the volume level by adjusting the volume control of

the connected device.

20.

STEREO PHONES Jack

Connect headphones to this jack.

* No sound is played through the unit’s

speaker while the STEREO PHONES

jack is in use.

If you use a PCS-31 connection cable,

you’ll also be able to use this as a stereo

recording output.

* If you're using a monaural cable, the

effect might be difficult to discern.

fig.01-01

21.

FOOT SW (Footswitch) Jack

A footswitch (BOSS FS-5U or FS-6; sold separately)

connected here can be used to switch on/off MUTE and

DELAY/REVERB for the MIC/LINE CH, and EFX and

DELAY/REVERB for the GUITAR/INST CH.

* If you use a monaural cable to connect just one footswitch,

you’ll only be able to control MUTE for the MIC/LINE CH,

and EFX for the GUITAR/INST CH.

22.

Security Slot ( )

http://www.kensington.com/

23.

AC Adaptor Jack

Connect the included AC adopter to this jack.

* Use only the AC adaptor included with the CUBE STREET.

24.

Grounding terminal

Depending on the circumstances of a particular setup,

you may experience a discomforting sensation, or

perceive that the surface feels gritty to the touch when

you touch this device, microphones connected to it, or

the metal portions of other objects, such as guitars. This

is due to an infinitesimal electrical charge, which is

absolutely harmless. However, if you are concerned

about this, connect the ground terminal with an external

ground. When the unit is grounded, a slight hum may

occur, depending on the particulars of your installation.

If you are unsure of the connection method, contact the

nearest Roland Service Center, or an authorized Roland

distributor, as listed on the “Information” page.

Unsuitable places for connection

• Water pipes (may result in shock or electrocution)

• Gas pipes (may result in fire or explosion)

• Telephone-line ground or lightning rod (may be

dangerous in the event of lightning)

25.

Cord Hook

Hook the AC adaptor cord here (p. 9).

TIP:L

RING:R

white(L)

red(R)

PCS-31

white

EFX

DELAY/REVERB

red

PCS-31

Polarity Switch

white

MUTE

DELAY/REVERB

red

PCS-31

CUBE-Street_egfispd.book Page 8 Thursday, June 28, 2007 8:55 AM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Roland CUBE STREET Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info