Bedienungsanleitung Roland DJ-808 (Seite 10 von 32) (Englisch)

710397

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

Panel Descriptions

DC IN jack

Connect the included AC adaptor here.

* Place the AC adaptor so the side with the indicator (see illustration)

faces upwards and the side with textual information faces downwards.

The indicator will light when you plug the AC adaptor into an AC outlet.

Power cord

AC Outlet

Indicator

* To prevent the inadvertent disruption of power to your unit (should the

plug be pulled out accidentally), and to avoid applying undue stress to

the jack, anchor the power cord using the cord hook, as shown in the

illustration.

[POWER] switch

This turns the power on/o.

* The power to this unit will be turned o automatically after a

predetermined amount of time has passed since it was last used for

playing music, or its buttons or controls were operated (Auto O

function).

If you do not want the power to be turned o automatically, disengage

the Auto O function.

For details on how to disable this function, refer to p. 22.

NOTE

5 Any settings that you are in the process of editing will be lost when

the power is turned o. If you have any settings that you want to

keep, you should save them beforehand.

5 To restore power, turn the power on again.

[MIC SENS] knob

Adjusts the mic input sensitivity.

MIC IN jack

Connect your microphone here.

You can use any one of three types of plugs (XLR, TRS, phone).

* Pin assignment of MIC IN jack

1: GND

2: HOT

3: COLD

GND (SLEEVE)

HOT

(TIP)

COLD (RING)

MASTER OUT 1 (L / R) connectors, 2 (L / R) jacks

Connect your powered speakers or power amp here.

* Pin assignment of MASTER OUT 1 connectors

BOOTH OUT (L / R) jacks

These are the output jacks for booth monitoring.

* Pin assignment of BOOTH OUT jacks

INPUT (CH 1–CH 4) jacks

These jacks input sound to channels 1–4. The CH1 and CH2 INPUT jacks

support phono input from MM-type cartridges.

Set the [INPUT SELECT] switch appropriately for the device you’re

connecting.

PHONO GROUND terminal

If a turntable (analog) is connected to the CH1 or CH2 INPUT jacks, connect

the turntable’s ground terminal here. This suppresses noise from the

turntable.

* Depending on the circumstances of a particular setup, you may

experience a discomforting sensation, or perceive that the surface feels

gritty to the touch when you touch this device, or the metal portions of

other objects. This is due to an innitesimal electrical charge, which is

absolutely harmless. However, if you are concerned about this, connect

the PHONO GROUND terminal with an external ground. When the unit

is grounded, a slight hum may occur, depending on the particulars of

your installation. If you are unsure of the connection method, contact

the nearest Roland Service Center, or an authorized Roland distributor,

as listed on the “Information” page.

Unsuitable places for connection

5 Water pipes (may result in shock or electrocution)

5 Gas pipes (may result in re or explosion)

5 Telephone-line ground or lightning rod (may be dangerous in the

event of lightning)

MIDI OUT connector

This outputs MIDI messages such as MIDI clock.

USB HOST ports

These are USB audio input ports.

Both ports 3 and 4 can supply USB bus power.

* For more about devices that can be connected, refer to the Roland

website.

PC port

Use the included USB cable to connect this port to your computer.

To connect this to your computer, you must install the USB driver.

& “Installing the Software” (p. 3)

Computer

* Use the cord hook to secure the USB cable as shown in the illustration.

This prevents the plug from being pulled out, or strain from being

applied to the port.

To prevent malfunction and equipment failure, always turn down the volume, and turn o all the units before making any connections.

Rear Panel (Connecting Your Equipment)

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Roland DJ-808 Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Roland DJ-808

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info