Bedienungsanleitung Roland DJ 99 - DJ Mixer (Seite 4 von 11) (Englisch)

652877

Zoom out

Zoom in

Vorherige Seite

1/11

Nächste Seite

IMPORTANT NOTES

Power Supply

• Do not connect this unit to same electrical outlet

that is being used by an electrical appliance that

is controlled by an inverter or a motor (such as a

refrigerator, washing machine, microwave oven, or

air conditioner). Depending on the way in which

the electrical appliance is used, power supply noise

may cause this unit to malfunction or may produce

audible noise. If it is not practical to use a separate

electrical outlet, connect a power supply noise lter

between this unit and the electrical outlet.

Placement

• Using the unit near power ampliers (or other

equipment containing large power transformers)

may induce hum. To alleviate the problem, change

the orientation of this unit; or move it farther away

from the source of interference.

• This unit may interfere with radio and television

reception. Do not use this unit in the vicinity of such

receivers.

• Noise may be produced if wireless communications

devices, such as cell phones, are operated in the

vicinity of this unit. Such noise could occur when

receiving or initiating a call, or while conversing.

Should you experience such problems, you should

relocate such wireless devices so they are at a

greater distance from this unit, or switch them o.

• When moved from one location to another where

the temperature and/or humidity is very dierent,

water droplets (condensation) may form inside

the unit. Damage or malfunction may result if you

attempt to use the unit in this condition. Therefore,

before using the unit, you must allow it to stand

for several hours, until the condensation has

completely evaporated.

• Depending on the material and temperature of the

surface on which you place the unit, its rubber feet

may discolor or mar the surface.

• Do not place containers or anything else containing

liquid on top of this unit. Also, whenever any liquid

has been spilled on the surface of this unit, be sure

to promptly wipe it away using a soft, dry cloth.

Maintenance

• Never use benzine, thinners, alcohol or solvents of

any kind, to avoid the possibility of discoloration

and/or deformation.

Additional Precautions

• Use a reasonable amount of care when using the

unit’s buttons, sliders, or other controls; and when

using its jacks and connectors. Rough handling can

lead to malfunctions.

• When disconnecting all cables, grasp the connector

itself—never pull on the cable. This way you will

avoid causing shorts, or damage to the cable’s

internal elements.

• A small amount of heat will radiate from the unit

during normal operation.

• To avoid disturbing others nearby, try to keep the

unit’s volume at reasonable levels.

• Do not use connection cables that contain a built-in

resistor.

About Trademarks

• Roland is either registered trademark or trademark

of Roland Corporation in the United States and/or

other countries.

• Company names and product names appearing

in this document are registered trademarks or

trademarks of their respective owners.

MAIN SPECIFICATIONS

Roland DJ-99: DJ Mixer

Nominal Input Level

(OUTPUT MASTER 0 dBu)

CH1, CH2 CD (L, R): -13 dBu

CH1, CH2 LN (L, R): -17 dBu

CH1, CH2 PH (L, R): -61 dBu

CH1, CH2 DVS RETURN (L, R): -13 dBu

MIC IN: -40 dBu

Maximum Input Level

CH1, CH2 CD (L, R): 6 Vrms

CH1, CH2 LN (L, R): 6 Vrms

CH1, CH2 PH (L, R): 0.04 Vrms

CH1, CH2 DVS RETURN (L, R): 6 Vrms

MIC IN: 0.6 Vrms

Maximum Output Level

(1 kHz, typ.)

OUTPUT MASTER (L, R): +15 dBu

OUTPUT BOOTH (L, R): +15 dBu

PHONES: 31 mW

Recommended Load

Impedance

PHONES: 32 ohms

Frequency Response

CH1, CH2 CD, LN, DVS RETURN: 20 Hz–20 kHz

(+1/-2 dB)

MIC IN: 20 Hz–20 kHz (+1/-3 dB)

Noise Level

CH1, CH2 LN (L, R) –> OUTPUT MASTER: 0.6 mVrms

or less

CH1, CH2 PH (L, R) –> OUTPUT MASTER: 6 mVrms

or less

*TRIM level: center, 1 k ohms terminated, MASTER

level: max, IHF-A, typ.

Distortion

CH1, CH2 CD (L, R): 0.2% or less

CH1, CH2 LN (L, R): 0.2% or less

Channel EQ (typ.)

HI: 10 kHz +12 dB– -12 dB

MID: 980 Hz +12 dB– -28 dB

LOW: 100 Hz +12 dB– -28 dB

Connectors

MIC input jack: 1/4-inch phone type

PHONES output jacks: Stereo 1/4-inch phone type,

Stereo miniature phone type

CH1, CH2 CD input jacks (L, R): RCA phono type

CH1, CH2 LN/PH input jacks (L, R): RCA phono type

CH1, CH2 DVS SEND jacks (L, R): RCA phono type

CH1, CH2 DVS RETURN jacks (L, R): RCA phono type

CH1, CH2 GND terminals

MASTER output jacks (L, R): 1/4-inch phone type

BOOTH output jacks (L, R): RCA phono type

POWER switch

POWER connector

Fuse holder

Power Consumption 22 W

Fuse Rating T315mAL250V (5 ф x 20 mm)

Dimensions

224 (W) x 306 (D) x 104 (H) mm

8-7/8 (W) x 12-1/16 (D) x 4-1/8 (H) inches

Weight

(excluding Power cord)

3.3 kg

7 lbs 5 oz

Accessories

Owner’s manual

Power cord

Extra fader knob: 3 pcs

* 0 dBu=0.775 Vrms

* This document explains the specications of the product at the

time that the document was issued. For the latest information,

refer to the Roland website.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Roland DJ 99 - DJ Mixer Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Roland DJ 99 - DJ Mixer

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info