Bedienungsanleitung Roland DP90Se (Seite 13 von 68) (Englisch)

710534

Zoom out

Zoom in

Vorherige Seite

1/68

Nächste Seite

Before You Play

Turning the Power On/O

Once everything is properly connected (p. 11), be sure to follow the

procedure below to turn on their power. If you turn on equipment

in the wrong order, you risk causing malfunction or equipment

failure.

NOTE

Before turning the unit on/o, always be sure to turn the volume

down. Even with the volume turned down, you might hear some

sound when switching the unit on/o. However, this is normal

and does not indicate a malfunction.

O

Min Max

Turning the power on

1. Move the [Volume] slider all the way to the left to

minimize the volume.

2. Press the [Power] switch.

After a brief interval, you’ll be able to produce sounds by playing

the keyboard.

* This unit is equipped with a protection circuit. A brief interval (a

few seconds) after turning the unit on is required before it will

operate normally.

3. Use the [Volume] slider to adjust the volume.

Adjust the volume while playing something on the keyboard, so

you can hear how it sounds.

This will adjust the volume of the speakers if you’re using

the speakers of the unit, or the volume of the headphones if

headphones are connected. Each volume setting (for speaker or

headphone) is saved automatically.

Volume adjustment screen

when using speakers

Volume adjustment screen

when using headphones

MEMO

The unit is designed so that nuances in the dynamics of your

playing will be clearly heard even at low volume, and that the

sound will remain clear even at high volume.

Turning the power o

1. Move the [Volume] slider all the way to the left to

minimize the volume.

2. Press the [Power] switch.

The power is turned o.

If you don’t want the power to turn o

automatically, change the “Auto O” setting to

“OFF”!

The power to this unit will be turned o automatically

after a predetermined amount of time has passed since

it was last used for playing music, or its buttons or

controls were operated (Auto O function).

If you do not want the power to be turned o automatically,

disengage the Auto O function (p. 39).

NOTE

• Any settings that you are in the process of editing will

be lost when the power is turned o. If you have any

settings that you want to keep, you should refer to

“Retaining the Settings Even After Power-o (Memory

Backup)” (p. 39) and save your settings.

• To restore power, turn the power on again (p. 13).

• When turning the power on again, you must allow at

least ve seconds after power-o before you once again

turn the power on. If you fail to allow enough time, the

Auto O function might not be reset, preventing the

power from turning on correctly.

Operation Guide Panel Descriptions Before You Play Performing Practicing

Convenient Functions

Appendix

Function Mode

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Roland DP90Se Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info