Bedienungsanleitung Roland PK-6 (Seite 6 von 164) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch)

538454

Zoom out

Zoom in

Vorherige Seite

1/164

Nächste Seite

Important notes

Dynamic MIDI Pedal

PK-6

1. Important notes

In addition to the items listed under “Using the unit safely” auf S. 4, please read and observe the following:

Power supply

• Do not connect this unit to same electrical outlet that is being

used by an electrical appliance that is controlled by an inverter

(such as a refrigerator, washing machine, microwave oven, or air

conditioner), or that contains a motor. Depending on the way in

which the electrical appliance is used, power supply noise may

cause this unit to malfunction or may produce audible noise. If it is

not practical to use a separate electrical outlet, connect a power

supply noise filter between this unit and the electrical outlet.

• The AC adaptor will begin to generate heat after long hours of

consecutive use. This is normal, and is not a cause for concern.

• To prevent malfunction and equipment failure, always make sure

to turn off the power on all your equipment before you make any

connections.

•With the factory settings, the PK-6 will automatically be switched

off 240 minutes (4 hours) after you stop playing or operating the

unit. If you don't want the unit to turn off automatically, change

the “Auto Off” setting to “Off” as described on S. 25.

Note:

The settings you were editing will be lost when the

unit is turned off. If you want to keep your settings, you

must save your settings before turning the unit off.

Power supply: Use of Batteries

•When installing or replacing batteries, always turn this unit off

and disconnect any other devices you may have connected. This

way, you can prevent malfunction and damage.

• The life of the supplied batteries may be limited, since its primary

purpose was to enable testing.

• If operating this unit on batteries, please use alkaline batteries.

Placement

• This device may interfere with radio and television reception. Do

not use it in the vicinity of such receivers.

• Noise may be produced if wireless communications devices, such

as cell phones, are operated in the vicinity of this unit. Such noise

could occur when receiving or initiating a call, or while conversing.

Should you experience such problems, you should relocate such

wireless devices so they are at a greater distance from this unit, or

switch them off.

• Do not expose the unit to direct sunlight, place it near devices that

radiate heat, leave it inside an enclosed vehicle, or otherwise sub-

ject it to temperature extremes. Excessive heat can deform or dis-

color the unit.

•When moved from one location to another where the temperature

and/or humidity is very different, water droplets (condensation)

may form inside the PK-6. Damage or malfunction may result if

you attempt to use the unit in this condition. Therefore, before

using the unit, you must allow it to stand for several hours, until

the condensation has completely evaporated.

• Do not allow objects to remain on top of the keyboard. This can be

the cause of malfunction, such as keys ceasing to produce sound.

• Depending on the material and temperature of the surface on

which you place the unit, its rubber feet may discolor or mar the

surface.

You can place a piece of felt or cloth under the rubber feet to pre-

vent this from happening. If you do so, please make sure that the

unit will not slip or move accidentally.

• Do not put anything that contains water (e.g. flower vases) on the

PK-6. Also, avoid the use of insecticides, perfumes, alcohol, nail

polish, spray cans, etc., near the unit. Swiftly wipe away any liquid

that spills on the unit using a dry, soft cloth.

Maintenance

• For everyday cleaning wipe the unit with a soft, dry cloth or one

that has been slightly dampened with water. To remove stubborn

dirt, use a cloth impregnated with a mild, non abrasive detergent.

Afterwards, be sure to wipe the unit thoroughly with a soft, dry

cloth.

• Never use benzene, thinner, alcohol or solvents of any kind, to

avoid the possibility of discoloration and/or deformation.

Repairs and Data

•Please be aware that all data contained in the unit's memory may

be lost when the unit is sent for repairs. Important data should

always be backed up in another MIDI device (e.g., a sequencer), or

written down on paper (when possible). During repairs, due care is

taken to avoid the loss of data. However, in certain cases (such as

when circuitry related to memory itself is out of order), we regret

that it may not be possible to restore the data, and Roland

assumes no liability concerning such loss of data.

Additional precautions

•Please be aware that the contents of memory can be irretrievably

lost as a result of a malfunction, or the improper operation of the

unit. To protect yourself against the risk of loosing important data,

we recommend that you periodically save a backup copy of impor-

tant data you have stored in the unit's memory, in another MIDI

device (e.g., a sequencer).

• Unfortunately, it may be impossible to restore the contents of data

that was stored in the unit’s memory once it has been lost. Roland

Corporation assumes no liability concerning such loss of data.

• Use a reasonable amount of care when using the PK-6’s buttons,

other controls and jacks/connectors. Rough handling can lead to

malfunctions.

• Never strike or apply strong pressure to the display.

•When connecting/disconnecting cables, grasp the connector

itself—never pull on the cable. This way you will avoid causing

shorts, or damage to the cable’s internal elements.

• To avoid disturbing others nearby, try to keep the unit's volume at

reasonable levels.

• The sound of pedals being struck and vibrations produced by play-

ing an instrument can be transmitted through a floor or wall to an

unexpected extent. Please take care not to cause annoyance to

others nearby.

•When you need to transport the unit, package it in the box

(including padding) that it came in, if possible. Otherwise, you will

need to use equivalent packaging materials.

• Use only the specified expression pedal (Roland EV-series, sold

separately) or pedal switch (Roland DP-series, BOSS FS-5U). By

connecting any other expression pedal or footswitch, you risk

causing malfunction and/or damage the unit.

•When you operate the pedals, please be careful not to get your

fingers pinched between the movable part and the panel. In places

where small children are present, make sure that an adult provides

supervision and guidance.

PK-6_multi.book Page 6 Friday, January 13, 2012 1:58 PM

Roland PK-6 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info