Bedienungsanleitung Rollei Actioncam SD20 (Seite 18 von 18) (Englisch)

761366

Zoom out

Zoom in

Vorherige Seite

1/18

Nächste Seite

FCC Notices

1. The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this

equipment. Such modifications could void the user's authority to operate the equipment.

2. This device complies with Part 15 of the FCC Rules. (1) This device may not cause harmful interference, and (2) this

device must accept any interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to

part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning

the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following

measures:

--Reorient or relocate the receiving antenna.

--Increase the separation between the equipment and receiver.

--Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

--Consult the dealer or an experienced radio/TV technician for help.

Notices for Waterproof Casing

The water-proof casing shall be installed precisely. Please notice following items during operation.

1.Do not disassemble and refix the sealing ring of casing, keys and lens cover by yourself. Otherwise,

the sealing of water-proof casing may be affected.

2.Do not place the casing in those environments where exist corrosive gas such as strong acid or alkali;

and keep it away from chemicals and other corrosives.

3.Do not put water-proof casing in high (above 50°C) or low (-10°C) temperatures for long period of

time to avoid casing deformation.

4.Do not expose the casing under direct sunshine for a long time to avoid deteriorating its

waterproofing performance.

5.Before using the casing, it's advised to check whether the seal rings are under good

condition,whether there are foreign objects at the sealing joints,whether the casing is well sealed and

tightly buckled.

6.After using the casing in sea water, please clean and flush it by fresh water firstly, and then use a dry

cloth to wipe the surface and put the device in a cool and ventilated place.

Please read this user manual carefully and thoroughly before any attempt to install and operate this

product and re-tain for your future reference.

-16-

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Rollei Actioncam SD20 Seite 18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Rollei Actioncam SD20

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info