25
• By touching the “+“ sensor (4) you can
increase the operating time in minute
intervals up to 99 minutes.
• By touching the
“
-“ sensor (5) you can re-
duce the operating time in minute inter-
vals.
• By continuously pressing the “+“ sensor
(3) or “-“ sensor (5) you can increase or
reduce the operating time in 5-minute
intervals.
• Once the set time has elapsed there is an
audible signal and the control automati-
cally switches over to standby mode.
NOTE: Changing the power or temperature level will not affect the set operating time.
Switching-off
• For switching-off touch the main switch
sensor (1).
• The display “temp“ (7b) shows “-L-“ or
“-H-“, depending on the residual heat on
the cooking zone. Also an audible signal
sounds. Now the control is in standby
mode.
NOTE: If the waste heat of the pot creates a temperature on the cooking zone of more than 50 °C
the display “temp” (7b) shows “-H-“ for HOT. As soon as the temperature has sunk below 50 °C,
the display “temp” (7b) shows “-L-“ for LOW.
When the unit is disconnected from the mains the display “temp” (7b) expires.
NOTE: It is normal for the fan to continue running in the standby mode after a long operation time.
OUR ADVICE: Electrical appliances featuring a standby mode consume some power also in
non-operating state. Save energy by disconnecting your appliance from the mains during non-
use periods by pulling the mains plug.
Before cleaning always disconnect the unit from the mains!
Let the appliance cool down before cleaning!
• Remove any coarse residues from the glass ceramic plate by means of a special glass scraper,
which is available in the specialised trade and in household equipment shops.
• Following that clean the cold glass surface with a damp cloth and some dishwater and wipe it
dry with a clean cloth or kitchen tissue. On the market there are suitable cleaning agents for
glass ceramic cooktops available with which the whole glass surface is treated by means of a
kitchen tissue until there is no soiling visible anymore.
• Never immerse the appliance into water and do not use steam jet appliances.
Cleaning and maintenance
