490021
16
Zoom out
Zoom in
Vorherige Seite
1/20
Nächste Seite
16
Automatic temperature control
The cooking zones feature an automatic temperature control, i. e. the set temperatures are kept
constantly through a correspondingly cycled energy supply. This can be observed by the heating
zones turning on and off. You will find the corresponding values for each cooking level in the
chart under point “Cooking level parameters”.
Please use the following settings
1 ... 3 for heating-up
4 ... 6 for steaming, stewing, boiling
7 ... 9 for parboiling, baking, roasting
Switching a cooking zone off
An active cooking zone is switched off by:
a) applying the PLUS and MINUS sensors simultaneously or
b) setting cooking level “0”.
Attention: By applying the ON/OFF sensor, the whole control (i. e. both cooking zones at the
double cooking plate) are switched off!
Residual heat indication
If a cooking zone is switched off and still emits residual heat, the display will show an “H” for
HOT. The display remains also active in off mode and will only distinguish if the appliance is
disconnected from the mains or if there is no residual heat. Do not touch the hot cooking zone!
The residual heat can be used for keeping-warm.
Dual-circuit
Your cooking plate features a dual-circuit heating zone which enlarges the cooking
surface (or one cooking surface at the double cooking plate) from 140 mm Ø to
210 mm Ø by setting an outer heating circuit in addition.
The set cooking level will not be changed by setting the dual-circuit in addition.
Activating the dual-circuit
The dual-circuit can only be activated if the respective cooking zone is active (cooking level
1 – 9). For activating the large heating zone, apply the corresponding dual-circuit sensor. The
glowing LED above the sensor shows you that the outer heating circuit 210 mm Ø is additionally
active.
Deactivating the dual-circuit
If you want to set back to the small heating circuit, apply the dual-circuit sensor again. The LED
above the sensor goes out and shows you that the outer heating circuit is deactivated.
16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Rommelsbacher CT3403 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info