Bedienungsanleitung Rommelsbacher WP250 (Seite 12 von 20) (Deutsch, Englisch, Französisch)

714016

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

becomes visible. This shows that the automatic heating system has been triggered. If the heat level is

reduced within 10 seconds by means of the – sensor, the automatic heating system remains activated

for all settings. As long as the automatic heating system is on, the hot tray is operated with maximum

power during the initial heating period, which is in return dependent on the heat level selected. Once

the automatic heating peak is over, the luminous point will go out and the hot tray has reached the

desired temperature.

Safety functions

The Touch Control technology features several safety functions so as to prevent any unintentional activation.

• If you do not trigger any further functions within 10 seconds after the appliance has been switched

on, the hot tray will automatically switch off again.

• Beyond that, its electronics detects whether the sensors are touched purposefully. If you place a kit-

chen towel or similar on the appliance, it will not get triggered. The same goes for liquids that might

run over the glass surface.

• The safety switch-off will also get triggered if one or several sensors are activated for more than

12 seconds. In this case the control system switches off the hot tray. In the heat level display, an ‘F’

ﬂashes up. In this case, please switch off the appliance completely via the POWER sensor and start

the keep warm procedure anew.

• When the appliance is switched on, the sensors adjust themselves automatically to the environmen-

tal conditions. During that adjustment the glass surface above the sensors must not be covered. Only

if it is exposed to extreme external light, or if it is covered with a light object, an adjustment will not

be possible. This will also be indicated through an ‘F’ in the heat level display. In this case too, please

switch off the appliance completely via the POWER sensor, remove the external light and the cover

respectively and start the keep warm procedure anew.

4. Temperatures

WP 250 and WP 350

Once switched on, these models heat up to the maximum temperature of about 105 °C and keep it until

switch-off.

WPR 305/E and WPR 405/E

These models feature a continuous temperature regulation from about 40 °C to about 105 °C.

WPE 308/TC

There are 9 temperature levels which can be selected:

1 approx. 40 °C 3 approx. 60 °C 5 approx. 75 °C 7 approx. 90 °C 9 approx. 105 °C

5. Cleaning and maintenance

Always unplug and let cool down the appliance before

cleaning. Never immerse appliance, power cord or plug in

water for cleaning. Make sure no water or steam may inﬁlt-

rate the appliance from below!

• Clean the appliance with a damp cloth and some dishwashing detergent. Dry it thoroughly.

• Treat the surfaces with suitable care products from time to time.

• Never use abrasives, solvents, steel wool or pointed objects!

• Never treat the appliance with a steam cleaner!

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Rommelsbacher WP250 Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info