Bedienungsanleitung Rowenta DW5127 Focus (Seite 8 von 70) (Alle Sprachen)

667611

Zoom out

Zoom in

Vorherige Seite

1/70

Nächste Seite

(*) Depending on model

USE

2 • Filling the water tank

IMPORTANT Before filling the water tank, unplug the iron and set the steam control to dry

position .

Tilt the iron. Open the filling inlet (fig.6). Pour in water up to the max mark (fig.7).

Close the filler inlet (fig.8) and return the iron to the horizontal.

3 • Temperature and steam adjustment

Set the iron temperature to suit the type of material using the temperature control

dial (fig.3).

Temperature control*: The temperature control light indicates that the soleplate is

heating up. When the temperature control light goes off (fig.10), the set

temperature is reached and you can begin ironing.

IMPORTANT The iron takes longer to cool down than to heat up. We recommend that you start

with fabrics to be ironed at a low temperature.

For mixed fabrics set the temperature for the most delicate fabric.

TIP Always spray starch onto the reverse side of the fabric to be ironed.

4 • Dry ironing

Set the variable steam control to (fig.11) and set the temperature to suit the type

of material (care points •, ••, •••).

5 • Steam ironing

You can steam iron from temperature setting •• upwards.

Steam function* : The steam quantity can be set to between no steam (minimum

steam quantity) and maximum steam quantity (fig.12).

We recommend setting to maximum steam quantity only when the iron is at

temperature setting •••.

6 • Shot of steam

(from temperature setting •• upwards)

Press the shot of steam button to generate a powerful jet of steam (fig.13).

Wait a few seconds between each shot before pressing the button again.

7 • Vertical shot of steam

(from temperature setting •• upwards)

TIP Hold the iron 10 to 20 centimetres away from the garment to avoid burning delicate fabrics.

Hold the iron to the vertical and press the shot of steam button ( fig.14) to remove

creases from suits, jackets, skirts, hanging curtains etc.

Wait a few seconds between each shot before pressing the button again.

IMPORTANT Never direct the steam at persons or animals!

8 • Spray

Press the spray button to dampen stubborn creases (fig.15).

9 • Anti-Drip system*

This prevents water escaping from the soleplate when the temperature is too low.

10 • Automatic electronic 3-position cut-off*

If, although switched on, the appliance is not moved, it will automatically switch off

and the auto off light will blink after the following intervals:

- After 30 sec., if the iron is left resting on the the soleplate or lying on its side.

- After 8 mins., if the iron is left resting on its heel.

To switch the iron back on, move the iron gently.

Ironing label Fabric

Temperature

control

Synthetic fibres, e.g.

viscose, polyester…

•

Silk, wool

••

Cotton, linen

•••

1103910049-index 02 DW5000 D1_110x220mm 03/02/15 11:03 Page4

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Rowenta DW5127 Focus Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info