Bedienungsanleitung Rowenta GS3010 (Seite 7 von 24) (Englisch, Französisch, Spanisch)

763385

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

Filling with water

• Your steam brush has been designed to

operate using untreated tap water. If

your water is very hard (check with your

local water authority) it is possible to

mix tap water with store-bought

distilled or demineralised water in the

following proportions:

-50% untreated tap water,

-50% distilled or demineralised water.

• Remove the water tank by pulling it back-

wards -

fig.3.

• Remove the stopper.

•

ill the watertank to the MAX level with

water -

fig.4

and close it securly. Make

sure that the stopper is properly pushed in

place -

fig.5

• Put the tank into the handle until it snaps

in -

fig.6

• Completely unwind the power cord. Plug

in your steam brush -

fig.7

USE

• Once the appliance is plugged in, the light is

on -

fig.8

• After approximately 50 seconds, and when

the light is off, it has reached working tem-

perature.

• To begin steaming, press by successive

pressures the steam trigger with the steam

brush facing away from you, holding it in

vertical position -

fig.9

Steaming clothes

The Ultra Steam is equipped with a fabric

brush.

• To attach the accessory, line it up with the

steam head. It locks into position with an

audible click -

fig.2/fig.11a

• Simply pull on the top of the fabric brush

to remove it -

fig.11b

. You can operate

the unit with or without the accessory.

• Hang the creased article of clothing on a

clothes hanger

• Pull the clothing tight with one hand. Your

hand must be far enough from the steam

brush to avoid burning it with the steam

output. Place the appliance over the crea-

sed area, beginning at the top of the gar-

ment.

• Gently press the fabric brush against the

clothing and move the steam brush down

the fabric. Press by successive pressures,

every 4 seconds, the steam trigger -

fig.9

• The combination of steam and brush will

gently remove the creases.

• After treatment, let the garment cool down

on the hanger before wearing.

• Remove the fabric brush once unit is un-

plugged and completely cool. Remove it by

pressing on the release tab on top of brush

while pulling it forward.

Lint pad

Threads, lint and hair can easily be

removed with the lint pad by brushing the

During use or while unit is heating or

cooling, do not rest appliance on its

head. Place product on its side on a

stable, heat resistant, flat surface, as

the head will be hot. As the

appliance heats, the housing

becomes warm. This is normal.

Before removing or attaching the

fabric brush, unplug your

appliance and let it cool down.

Important: Heat concentrates the

elements contained in water during

evaporation.

Warning ! Never use 100%, distilled

or demineralised water as this can

cause the appliance to spit.

As steam is very hot: never attempt

to remove creases from a garment

while it is being worn, always hang

garments on a clothes hanger.

Always keep your hand far from the

steam output.

The lint pad can not be used when

attached to appliance.

1800129617 DR6000 U1_110 x 154 30/10/13 10:45 Page3

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Rowenta GS3010 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info