Bedienungsanleitung Rowenta IS6202 (Seite 16 von 116) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Türkisch, Schwedisch)

763319

Zoom out

Zoom in

Vorherige Seite

1/116

Nächste Seite

• After closing the cap, turn the tank down and hold it by the handle. Check out that no

water is leaking through the cap.

• Place the water tank on the base (fig. 9).

USE

• Only operate the steamer on the floor clear of any materials which may obstruct the

base of the steamer (flat and horizontal surface). Do not obstruct the openings on the

lower part of the appliance. This appliance should not be used on very thick carpets

or rugs.

• Undo the Velcro strip and completely unwind the electrical cord. (fig.10)

• Plug in to power socket. (fig.11)

• Switch on by pressing the pedal located at the front of the appliance. The power indi-

cator light will come on. (fig.12)

• The appliance will begin producing steam after approximately 60 seconds.

• Hang the garments from the built-in hanger or from another hanger which may be sus-

pended from the hook located on the hanger rod. To steam trousers, we recommend

that you also use the support with clips as indicated in the illustration. (fig.14)

• Grasp the steam head with the steam vents pointing away from you.

• Start steaming by brushing material lightly with the grain of the fabric in an up/down

vertical motion. The fabric brush opens the weave of the fabrics for better steam pe-

netration.

• Start at the top the garment and gradually move downward (fig.13). Always steam in

a vertical position.

• For more ease, we recommend to pull the garment downward with your free hand while

steaming. Be careful not to touch the hot steam.

• During use, the hose may make a gurgling noise. This is a normal occurrence due to

condensation. If the appliance begins to gurgle, rest the steam head on its support for a

few moments in order to direct the condensation into the appliance once again.

ACCESSORIES

Before using an accessory, check the manufacturer recommendations.

It is also recommend that you carry out a test on part of the fabric which cannot be seen.

Fabric brush

The fabric brush opens the weave of the fabrics for better steam penetration.

• Attach the fabric brush to the steam head by lining up the bottom of the brush with the

bottom of the steam head. Gently push the top of the brush onto the steam head until

it clicks into place.

• Gently brush the area to be steamed with the

grain or nap of the fabric.

• Remove the fabric brush once unit is unplugged

and completely cool. Remove it by pressing on

the release tab on top of brush while pulling it

forward.

Warning: Never steam a garment while it is being worn.

The flexible pipe and the end of the steam head can become extremely hot during

use. This is perfectly normal. Be careful and avoid any prolonged contact.

Be sure unit is unplugged and completely cool before attaching accesories.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Rowenta IS6202 Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info