Bedienungsanleitung Rowenta RO8053 (Seite 15 von 101) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Türkisch)

762707

Zoom out

Zoom in

Vorherige Seite

1/101

Nächste Seite

1616

If your vacuum cleaner will not start

• The appliance is not powered. Check that the

appliance is plugged in correctly.

If your vacuum cleaner has no suction power

• An accessory, the tube, the flexible hose or

the pipe between the suction inlet (9) and the

separator are blocked, unblock them.

• The separator cover is blocked: remove the

filter and clean it.

• The HEPA filter is dirty: clean it (see Cleaning

and Maintenance paragraph). If the HEPA filter

is damaged, change it.

• The cover is not closed correctly: close it.

If your vacuum cleaner has less suction power,

is noisy or makes a whistling noise

• An accessory, the tube, the flexible hose or

the pipe between the suction inlet (9) and the

separator are blocked, unblock them.

• The dust container is full: empty it and wash

it.

• The dust container is not correctly fitted. Fit it

correctly (fig.27).

• The filter system (3 and 5) is saturated: see the

Cleaning and Maintenance paragraph. If the

HEPA filter is damaged, change it.

• The separator cover (3) is blocked: remove the

filter and clean it.

• The power control switch (16c) is open: close

the power nozzle power switch.

• There is an air leak. Check that the dust

container is locked. Check that the end of the

flexible hose (16d) is fitted correctly. Check that

the filter system is fitted (3 and 5).

If the separator fills up

• Dust accumulates in the bottom of the separator.

Check that the pipe between the bottom of the

separator and the dust container is not blocked.

Remove the filter assembly (3 and 5) and tap it

gently against the side of the bowl to remove any

excess dust (fig.23).

• The inlet of the dust container is blocked.

Remove the dust container and empty it. Clean

the opening of the dust container (9).

If it is difficult to move the nozzle

• Open the power nozzle power switch (16c).

If the power cord does not rewind completely

• The power cord is slowed down when

rewinding: pull the power cord out again and

press the power cord rewind button.

If a problem persists, take your vacuum cleaner

to your local Rowenta Approved Service

Centre. Check the attached list of Rowenta

Approved Service Centres or contact the

Rowenta customer service.

WARRANTY

• This product has been designed for domestic

use only. Any professional use, inappropriate

use or failure to comply with the instructions,

the manufacturer accepts no responsibility

and the guarantee will not apply.

• Read the instructions for use carefully before

using your appliance for the first time: any

use which does not conform to these

instructions will absolve Rowenta from any

liability.

TROUBLESHOOTING

IMPORTANT As soon as you notice that

your vacuum cleaner is not operating as well,

before carrying out any checks, switch it off

using the ON/OFF button and unplug the

power cord.

751271_SF Cyclonic_16L_751271 08/12/10 11:23 Page16

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Rowenta RO8053 Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info