Bedienungsanleitung Rowenta VU2410 (Seite 10 von 12) (Englisch, Französisch)

763138

Zoom out

Zoom in

Vorherige Seite

1/12

Nächste Seite

– The appliance is in a normal operating position (in an upright position on its feet).

• This appliance must not be used in a damp room.

• The rubber feet on this product may interact with wood and cause damage to furniture. Do not place on

ne wood furniture.

VOLTAGE

•Before using for the rst time, check that the voltage of your mains supply is the same as that shown on

theappliance and that your mains supply is suitable for the power indicated on the appliance.

ASSEMBLING

•Your appliance is supplied unassembled.

It is essential to assemble it correctly. To reduce the risk of re, electric shock, and injury to persons, this fan

must be installed according to this instruction.

•You must set and use your appliance in compliance with the standards in force in your country.

USER SERVICING INSTRUCTIONS

Fused plug

This plug is a safety feature. It contains a safety device (fuse) that should not be removed. Discard product if the

attachment plug is damaged.

To reduce the risk of re, electric shock and personal injury, do not remove, replace, repair or tamper with the

originally supplied plug.

If the fan does not function properly, it may be due to the safety device incorporated in this plug.

If the fuse fails, it is generally due to a short circuit or circuit overload. Replace the fuse as per the instructions

below.

If the replacement fuse fails, immediately unplug the unit and contact Rowenta consumer services for assistance.

This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electrical shock, this

plug is intended to t in a polarized outlet only one way. If the plug does not t fully in the outlet, reverse the plug.

If it still does not t, contact a qualied electrician. Do not attempt to defeat this safety feature.

Fuse replacement :

1. Grasp plug and remove from the receptacle or other outlet device. Do not unplug by pulling on cord. (A)

2. Open the fuse (B) by sliding the fuse cover on the top of the plug towards the blades.

3. Remove fuse (C) carefully by gently prying out the ends of the fuse from the receptacle.

Warning! Only replace with a fuse type and rating matching what was removed from the product.

4. Risk of re. Replace the fuse only with 2.5 Amp, 125 Volt fuse. Gently install replacement fuse back into the

pins that will hold it in place. (D)

Note : If the fuse is not seated properly, the unit will not function.

5. Close fuse cover (E) by sliding the fuse cover back over the fuse box in the plug until it is completely closed.

6. Plug the fan back in and resume use.

APPLIANCE(S) WITH REMOTE CONTROL VU2410U7/ VU2410U8 and VU2410:

VU2410U7/ VU2410U8 and VU2410 : Remote control : the battery 3V button cell (CR2032) is included.

WARNING: Chemical Burn Hazard. Keep batteries away from children.

ABCDE

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Rowenta VU2410 Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info