9
PARTS OF THE TOOL
1 - Identification label
2 - On/off switch
2A - Switch lever
2B - Switch block
3 - Speed control
4 - Shaft
5 - Auxiliary handle
6 - Protective suction hood
7 - Roller retainer spacer
8 - Screw and washer
9 - Roller shaft
10 - Motor ventilation slots
11 - Connection for 29 mm suction hose
12 - Side guard with tightening knob
13 - Gauged plate
14 - Hood angle list
15 - Sliding pins
16 - Abrasive roller
17 - Keys
STARTING UP
Before starting-up the tool, ensure that:
- the packaging is complete and does not show signs of having been
damaged during storage or transport;
- the tool is complete; check that the number and type of compo-
nents comply with that reported in this instruction booklet;
- the power supply and socket outlet can support the load reported in
the table and that indicated on the tool identification plate reprodu-
ced and explained on page 11.
ASSEMBLING THE TOOL
- Loosen the side guard (12) by unscrewing the tightening knob and
turn it away to make room for assembly of the roller (18);
- position the roller on the roller shaft (9);
- if the roller is 50 mm long, also assemble the spacer provided (7);
- lock the assembly in place using the roller lock screw (8) and the
key provided (17);
- tighten the guard again;
- connect up the suction hose (11).
BEFORE STARTING THE TOOL
Ensure that:
- the power supply conforms with the characteristics of the tool;
- the power supply cable and plug are in perfect condition;
- the ON/OFF switch works properly though with the power supply di-
sconnected;
- all the parts of the tool have been assembled in the proper manner
and that there are no signs of damage;
- the ventilation slots are not obstructed;
- the tool must be connected to a suitable and efficient aspiration device.
STARTING AND STOPPING
SR100AEN
- Starting:
push the slide of the switch (2) forward; if the tool is to be
locked in the ON position, apply pressure to the front part of the sli-
de switch at the same time.
- Stopping:
release the slide or, if locked in position, apply pressure
to the back part of the switch and allow it to return to the stop posi-
tion.
SR200AE
- Starting: press the locking button (2B) on the upper section of the
handle, then the switch lever (2A). To lock the spindle shaft in order
to be able to carry out a continuous machining, press the switch
lever (2A), then the locking lever (2B) and hold it down while
releasing the switch lever (2A), so that is firmly maintained in
position.
- Stopping
: release the switch lever or, if this is blocked, push the
lever in order to release the locking button.
