Bedienungsanleitung Russell Hobbs 19460-56 (Seite 66 von 72) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Türkisch, Schwedisch, Norwegisch, Finnisch)

509795

Zoom out

Zoom in

Vorherige Seite

1/72

Nächste Seite

Read the instructions, keep them safe, pass them on if you pass the appliance on.

Remove all packaging before use.

A IMPORTANT SAFEGUARDS

Follow basic safety precautions, including:

1 This appliance must only be used by or under the supervision of a responsible adult. Use and

store the appliance out of reach of children.

2 Don’t put the appliance in liquid, don’t use it in a bathroom, near water, or outdoors.

3 Unplug the appliance before ﬁtting or removing attachments.

4 Keep your hands away from the blades – they’re sharp

5 Don’t ﬁll with anything hotter than you can comfortably handle (i.e. liquid temperature

below 40°C).

6 The appliance is ﬁtted with a safety switch to prevent the motor operating unless the jug is in

place and the lid correctly ﬁtted. Don’t use this to switch the appliance on and oﬀ.

7 Don’t leave the appliance unattended while plugged in.

8 Don’t let the jug overﬂow. If liquid gets under the motor unit, it may be sucked into the motor,

damaging it.

9 Don’t run the motor continuously for more than 5 minutes, it may overheat. After 5 minutes

switch oﬀ for at least 2 minutes, to recover.

10 Don’t use accessories or attachments other than those we supply.

11 Don’t use the appliance for any purpose other than those described in these instructions.

12 Don’t use the appliance if it’s damaged or malfunctions.

13 If the cable is damaged, it must be replaced by the manufacturer, its service agent, or

someone similarly qualiﬁed, in order to avoid hazard.

household use only

C PREPARATION

1 Sit the motor unit on a dry, ﬁrm, level surface, near a power socket.

C FIT THE DRIVE SHAFT

2 Push the drive shaft up through the bottom of the jug.

3 Use the tabs to turn it clockwise and lock it to the bottom of the jug.

, If you need to rinse the jug, turn the tabs anti-clockwise, and remove the drive shaft ﬁrst, to

avoid getting it wet.

C FIT THE JUG

4 Sit the jug on the motor unit, with the handle to the right of the controls.

5 Turn the jug clockwise to bring the handle between the controls.

C FIT THE ACCESSORY

6 To process, ﬁt the chopper over the pillar in the centre of the jug.

7 To grate or slice:

a) Fit the disc support inside the pillar, over the drive shaft.

b) Lower the disc on to the disc support.

c) To slice, the slicing blade must be on top of the disc.

d) To grate, the slicing blade must be on the bottom of the disc.

C FIT THE LID

8 Hold the lid over the jug, with the safety switch to the right of the handle.

9 Lower the lid on to the jug.

10 Turn the lid clockwise to bring the safety switch into the gap at the top of the handle.

11 The controls will only operate with the lid and jug in this position.

12 The jug will not move while the safety switch is engaged.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Russell Hobbs 19460-56 Seite 66

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info