Quick Set-up Reference
Step 1 Insert batteries (checking correct polarity)
Step 2 Choose the device you want to control by turning
the adjusting ring until the printed ”TV”, ”VCR” or
”SAT” is inline with the pointer on the housing of
your remote.
Step 3 Switch on the chosen device TV, VCR, SAT. (if
setting up for TV, then TV must be fully on with a
broadcast picture on the screen)
Step 4 Press and hold the (F) key until the LED flashes
twice in quick succession.(approx 2 seconds)
Step 5 After the two flashes, remove your finger from the
(F) key and within 5 seconds input the code from
the manual.
Step 6 After you have input the code, wait for the LED to
flash twice, this confirms that the number you
selected has been installed into the unit correctly.
Step 7 Once the code has been installed, press the
(ON/OFF) key on the controller. If the (TV etc)
responds by going into standby mode then
continue to try all the other functions. If some
functions do not work correctly then move onto
the next code in the list repeating from Step 3.
What to do if the TV does not respond
• Either the 4-digit code, or part of the programming
sequence was not completed within 5 seconds or the
code was not recognised. Please re-check the 4-digit
code in the manual or move onto the next code in the list
against your particular brand. Also ensure that the codes
entered are from the correct section of the manual.
User Manual
Helpline 00800 31133113
6
