9
GB
F D E
English
I P NL S DK N FIN GR H CZ RUS RO PL
TR
CHARGER SAFETY
a. That pins on plug of extension cord are the same
number, size and shape as those of plug on charger.
b. That extension cord is properly wired and in good
electrical condition.
■ Do not operate charger with a damaged cord or plug.
If damaged, have it replaced immediately by a
qualified serviceman.
■ Do not operate charger if it has received a sharp
blow, been dropped, or otherwise damaged in any
way; take it to a qualified serviceman.
■ Do not disassemble charger; take it to a qualified
serviceman when service or repair is required.
Incorrect reassembly may result in a risk of electric
shock or fire.
■ To reduce risk of electric shock, unplug the charger
from outlet before attempting any maintenance or
cleaning. Turning off controls will not reduce this risk.
■ Disconnect charger from power supply when not in use.
■ Risk of electric shock. Do not touch uninsulated portion
of output connector or uninsulated battery terminal.
■ Save these instructions. Refer to them frequently and
use them to instruct others who may use this unit.
If you loan someone this unit, loan them these
instructions also.
DESCRIPTION
See Figure 1-9.
1. Keyless chuck
2. Switch trigger
3. Direction of rotation selector (Forward/Reverse)
4. Screwdriver bits
5 . Battery pack
6. Battery indicator
7. Latches
8. Depress latches to release battery pack
9. Auxiliary Handle(For CMI-1202/1442/1802)
10. To Tighten
11. To Loosen
12. Drill bit
13. Depth Gauge Rod(For CMI-1202/1442/1802)
14. Drilling Depth
15. To Decrease torque
16. To Increase torque
17. Torque adjusting Ring
18. Drill mode
19. Impact mode (For CMI-1202/1442/1802)
20. Reverse
21. Forward
22. Chuck jaws
23. Unlock (release)
24. Lock (tighten)
25. High Speed
26. Low Speed
27. Battery Charger
28. Green Light
29. Red Light
OPERATION
LED FUNCTION OF CHARGER
See Figure 9.
LED WILL BE ON TO INDICATE STATUS OF CHARGER
AND BATTERY PACK:
■ Red LED on = Fast charging mode.
■ Green LED on = Fully charged battery pack.
■ No LED on = Defective charge or battery pack.
CHARGING YOUR BATTERY PACK
The battery pack for your tool has been shipped in a low
charge condition to prevent possible problems.
Therefore, you should charge it prior to use.
Note: Batteries will not reach full charge the first time
they are charged. Allow several cycles for them to
fully charge.
TO CHARGE
■ Charge battery pack only with the charger provided.
■ Make sure power supply is normal house voltage,
230 volts, 50 Hz, AC only.
■ Connect charger to power supply.
■ Place battery pack in charger. Align raised rib on
battery pack with groove in charger.
■ Press down on battery pack to be sure contacts on
battery pack engage properly with contacts in charger.
When properly connected, red light will turn on.
■ When your battery pack becomes fully charged, the
red light will turn off and the green light will turn on.
■ After normal usage, 1 hour of charge time is required
to be fully charged. A minimum charge time of 1 to
1-1/2 hours is required to recharge a completely
discharged tool.
■ DO NOT place charger in an area of extreme heat or
cold. It will work best at temperatures above 10°C
and below 38°C.
