Bedienungsanleitung Sabo 47-EL VARIO (Seite 56 von 91) (Deutsch, Englisch, Holländisch, Französisch)

661041

Zoom out

Zoom in

Vorherige Seite

1/91

Nächste Seite

ATTENTION

When starting the motor, only the red safety grip may be used. The drive may only be switched on using the black

drive switch operating lever once the motor is running. If the black operating lever is applied first, the drive is

switched on at the same time leading to excess load on the motor.

10 SWITCHING OFF THE MOTOR (Illustration F )

– Release the black drive switch operating lever (1) - mower comes to a standstill.

– Release the red safety grip (2) - motor switches off.

The automatic blade brake stops the blade within 3 seconds.

11 EMERGENCY STOPPING

ATTENTION

Avoid injury! Motor and blade must stop within 3 seconds. If not, please contact the nearest authorized dealer.

Release the safety grip and the drive switch bar.

– The mower will stop.

– The blade will stop.

– The motor will stop.

12 MOVEMENT DRIVE

Operating the rear wheel drive (Illustration G + E2 )

IMPORTANT

The rear wheel drive may only be adjusted when the engine is running in order to avoid damage!

The rear wheel drive is switched on and off using the black drive switch operating lever (1) on the upper handle (2) when the

motor is running G :

– Press drive switch operating lever and hold = mower runs.

– Release drive switch operating lever = mower stops (0 position).

When the drive switch operating lever (1) is kept pressed, the red safety grip for the motor (2) is automatically kept in the

operating position E2 .

Adjusting the speed (Illustration H )

IMPORTANT

The speed may only be adjusted when the engine is running in order to avoid damage!

The operating speed can be continuously adjusted using the operating lever of the variable speed switch mounted on the

left-hand side.

– First, push the lever downwards to unlatch (1) and then set the desired driving speed (2) by adjusting the position of the

lever. The lever automatically clicks back into the nearest new position.

– Position “hare” = fast (max. speed).

– Position “tortoise” = slow (min. speed).

NOTE

Mowing at high speed leads to poor cutting pattern or collection result. Always adapt the speed to the prevailing

conditions. For longer grass sections, a slower moving speed should be selected.

13 MOWING

Safety instruction!

See table for explanation of symbols page 3

Mowing on slopes

ATTENTION

The mower can be operated on slopes and inclines up to an angle of 30°.

For reasons of safety, however, we urgently recommend that you do not attempt to exploit this theoretical potential

capacity to the full. Hand-held lawnmowers should never be used on slopes steeper than 15°.

Handling the cable during use

Position the cable in such a way that the machine can pull it along easily over the lawn surface that has already been

worked. When the machine turns the cable grip automatically positions the cable to the other handle side. Ensure that the

cable is kept well away from the cutting tool and that no loops are formed. Check the mains cable regularly for signs of

damage and only use it in proper condition.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sabo 47-EL VARIO Seite 56

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info