576463
108
Zoom out
Zoom in
Vorherige Seite
1/134
Nächste Seite
Appendix A - Troubleshooting
SAGEM F@st™ 1500 Reference Manual - 288053220-03
Page A-2 Reproduction and communication prohibited without the written permission of E
E E
E
This section describes common problems you may encounter and possible solutions to them.
The SAGEM F@st
TM
1500 ADSL Router can be easily monitored through panel indicators to
identify problems.
Troubleshooting Chart
Symptom Action
LED Indicators
The PWR LED is Off.
• Check connections between the SAGEM F@st
TM
1500 ADSL Router, the
external power supply, and the wall outlet.
• If the power indicator does not turn on when the power cord is plugged in, you
may have a problem with the power outlet, power cord, or external power
supply. However, if the unit powers off after running for a while, check for loose
power connections, power losses, or surges at the power outlet. If you still
cannot isolate the problem, then the external power supply may be defective.
In this case, contact Technical Support for assistance.
The ADSL LED is Off.
• Verify that the SAGEM F@st
TM
1500 ADSL Router and attached device are
powered on.
• Be sure the cable is plugged into both the ADSL Router and the
corresponding device.
• Verify that the proper cable type is used and that its length does not exceed
the specified limits.
• Be sure that the network interface on the attached device is configured for the
proper communication speed and duplex mode.
• Check the adapter on the attached device and cable connections for possible
defects. Replace any defective adapter or cable if necessary.
Network Connection Problems
The user cannot ping the
SAGEM F@st
TM
1500
ADSL Router from the
attached LAN.
• Verify that the IP addresses are properly configured. For most applications,
you should use the A DSL Router’s DHCP function to dynamically assign IP
addresses to hosts on the attached LAN. However, if you manually configure
IP addresses on the LAN, verify that the same network address (network
component of the IP address) and subnet mask are used for both the
SAGEM F@st
TM
1500 ADSL Router and any attached LAN devices.
• Be sure the device you want to ping (or from which you are pinging) has been
configured for TCP/IP.
Management Problems
The user cannot connect
using the web browser.
• Be sure to have configured the SAGEM F@st
TM
1500 ADSL Router with a
valid IP address, subnet mask, and default gateway.
• Check that you have a valid network connection to the SAGEM F@st
TM
1500
ADSL Router and that the port you are using has not been disabled.
• Check the network cabling between the management station and the
SAGEM F@st
TM
1500 ADSL Router.
The user forgot or lost the
password.
• Press the Reset button on the rear panel (holding it down for at least five
seconds) to restore the factory defaults.
108

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Sagem Fast 1500WG wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info