7. USING YOUR SET TOPBOX
22
7-12 RADIO MODE
Press the key on the remote control unit of the Set
Top Box.
You can move through the list displayed using and
.
You can adjust the volume.
7-13 SET TOPBOX ENHANCEMENT
The Set Top Box goes in this state when a new version of software is available on the network after
startup.
• Red led flashes.
• The Welcome screen is displayed.
Then a screen for “ download process ” request is displayed.
You can delay the downloading process by pressing the
EXIT key. This process will be displayed again the next
time you switch on your Set Top Box.
When pressing the key, the downloading will be
performed:
• Then the screen becomes black,
• Flash on led.
During this mode, no action from the user is
authorized.
On completion the set top box switch on automaticaly.
After startup an information screen is displayed on
download completed. Then press and enjoy with
your last viewed program.
Note: if the download process is not correctly perfor-
med, the screen stays black and the green led flashes
indicating the cause of the failure (see table below).
When an error occurs, press any key on the remote to
continue. Then put the Set Top Box in standby mode
and switch it back on to perform downloading again.
If this operation does not succeed, unplug the main
cord and the antenna cord. Then plug them again to
perform downloading again.
A DOWNLOAD OF SOFTWARE IS NECESSARY.
IT TAKES A FEW MINUTES.
YOUR SCREEN WILL BE BLACK.
DURING THIS TIME.
PRESS OK OTHERWISE EX TO EXIT.
