Bedienungsanleitung Salter SL2015-1 (Seite 3 von 19) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Schwedisch, Norwegisch, Finnisch)

518503

Zoom out

Zoom in

Vorherige Seite

1/19

Nächste Seite

USING THE SCALE

TO SWITCH TO ‘SCALE MODE’

TO MEASURE SOLIDS & LIQUIDS

a) Place the weighing platform on the

worksurface, below the display panel, with

the IR sections aligned and unobstructed.

b) If using a bowl,place it on the weighing platform.

c) The action of placing the weighing platform

on the worksurface will usually be sufficient to

switch the display to ‘scale mode’ automatically.

If not, just tap the front edge of the platform

to activate ‘scale mode’ on the display.

d) Always check that the display shows 0 before

weighing. If necessary, press the zero key to

reset the display to 0.

• To convert between grams (g) and ounces

(oz): press g-oz.

• To measure liquids: press ml-floz.

• To convert between millilitres (ml) and fluid

ounces (fl. oz): press ml-floz again.

• To switch back to solid (dry) measurement:

press g-oz.

O ADD ANDWEIGH

UTO SWITCH OFF

To weigh several different ingredients into one

bowl: press zero to reset the display between

each ingredient.

Automatic switch off occurs if the display

shows either ‘0’ or the same weight reading

for 3 minutes. (The backlight switches off after

1 minute).

When the scale switches off, the display will

automatically return to clock mode.

When display is showing time and temperature:

To change between 12 hour and 24 hour display, press g-oz briefly.

To change between °C and °F display, press ml-floz briefly.

To illuminate the display for 10 seconds, press zero briefly.

DDITIONAL DISPLAY FUNCTIONS IN CLOCK MODE

For correct operation a clear path is required

between the red lens on the weighing platform

and the red lens on the display panel.To help

achieve this, ensure that the IR sections on both

the display panel and weighing platform are

aligned with each other.

Note: Avoid placing large ‘overhanging’

items on the platform as this may obstruct

the IR signal. Should the IR signal become

obstructed during weighing, the display will

return to ‘clock mode’. Removing the obstruction

promptly will restore the signal.

TAP!

LOW BATTERY WARNING

Replace batteries in scale

(4 x AAA).

Always remove ‘low’

batteries promptly.

Never mix old and

new batteries or different

battery types.

Replace batteries in display

module (3 x AAA).

OVERLOAD WARNING

Total load applied exceeds

max. capacity of scale.

Remove excess load.

ADVICE & CARE

MORE ABOUT LIQUID MEASURES

The aquatronic

is programmed to measure all

water based liquids. In practical terms this

covers almost every liquid used in domestic

cookery including wine, milk, cream etc.

The exception is oil, which is not water based

and would therefore not give such an accurate

measure. (The error would be approx. +10%).

CLEANING

Clean the scale with a slightly damp cloth.

DO NOT immerse the scale in water or use

chemical / abrasive cleaning agents.

All plastic parts should be cleaned immediately

after contact with fats, spices, vinegar and

strongly flavoured / coloured foods. Avoid

contact with acids such as citrus fruits.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Salter SL2015-1 Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info