Bedienungsanleitung Salus RXRT510 (Seite 1 von 2) (Englisch)

735251

Zoom out

Zoom in

Vorherige Seite

1/2

Nächste Seite

Quick Guide Installation

Model: RT510 / RT510RF / RT510TX / RT510BC / RXRT510

Always isolate the AC Mains supply before installing or working

on any components that require 230 VAC 50Hz supply.

Introduction

The RT510 thermostat will switch your heating system on or o, as needed, in accordance with the temperature set

by you. The RT510 series includes the following products:

• RT510 for wired applications

• RT510RF (RT510TX + RXRT510) for wireless applications

• RT510TX for wireless application, using 5 x 5 receiver

• RXRT510 for wireless application using 5 x 5 transmitter

• RT510BC for wireless application

Go to www.salus-manuals.com for the full PDF version of the manual.

Product Compliance

EU Directives: 2014/53/EU and 2011/65/EU. Please check www.saluslegal.com for the full information.

Safety Information

Use in accordance with the EU and national regulations. For indoor use only.

Keep your device completely dry. This product must be installed by a competent person and in accordance with all

the EU and national regulations.

Button Functions RT510 and RT510TX Pairing the RT510TX with the Receiver/Boiler Controller

Installer Mode

Dip Switch Settings

RT510 & RT510RF Quick Guide

RESET

+Hr

SELECT SET

RESET

+Hr

SELECT SET

TEST / PAIRING

SELECT

+Hr

SET

TEST / PAIRING

SELECT

+Hr

SET

RT510 RT510TX

COMNO L N

Terminal Description Receiver Terminals

COM

Switch Terminal

Common Switch Terminal

Mains Live (230VAC)

Mains Neutral

RT510BC (RT510TX+Boiler Controller)

Wire up the boiler controller and switch it ON. After that please insert the

batteries into the thermostat.

Leave the link wire in the boiler

Remove the link wire in the boiler

NL1234

NL123456

NL1234 NL123456

1234

Terminal Description Plug in BC terminals

4 (NO)

3 (COM)

2 (L)

1 (N)

Switch Terminal

Common Switch Terminal

Mains Live

Mains Neutral

The DIP switches are found on the rear of

your thermostat and can be used to change

the span (temperature accuracy) of your

thermostat from the default +/-0.5°C to

+/-0.25°C and the programmes 5-2 or 24h.

Changing DIP Switch 2 may cause your boiler

to operate more frequently. The DIP switches

are located on the back of the thermostat.

24H

5-2

+/-0.25

+/-0.5

Key Function

+Hr

SELECT

SET

1. Press once to activate Frost Mode

2. Press for 3 seconds in order to activate Holiday Mode.

Press once to activate/deactivate Boost function

Press once to enter/exit Permanent Override function.

Increase button

Decrease button

Select the clock or programme settings

Press to conrm your settings

Press the buttons for 3 seconds to enter Installer Mode

Press the buttons for 3 seconds to enter Clock Settings

1. Press once to enter in Test Mode for RT510RF

2. Press for 3 seconds to enter/exit Pairing Mode for RT510RF

3. Press once to return to Factory Settings for the RT510

RESET

+Hr

SELECT SET

3 Sec 3 Sec

3 Sec

Press the three buttons

together for 3 seconds.

dxx Function Parameter Description Default

value

d01

Temperature display

increments

0.1 or 0.5°C

Select temperature display

increments

0.5°C

d02 Temperature oset +/-3.0°C

Calibrate your thermostat

temperature

0.0°C

d03 Frost setpoint 5.0-17.0°C Set the Frost Point temperature 5.0°C

If you are using the RT510RF or RT510BC pack, the pairing between

the thermostat and the receiver/boiler controller is already done.

If you bought an RT510TX and RXRT510 separately then pair as follows.

Please make sure that the Receiver/Boiler Controller is set on Auto.

Begin the pairing process

TEST / PAIRING

SELECT

+Hr

SET

TEST / PAIRING

SELECT

+Hr

SET

TEST / PAIRING

SELECT

+Hr

SET

3 Sec

AUTO

OFF

MANUAL

TEST / PAIRING

SELECT

+Hr

SET

Wait 9 minutes for the timeout

process to be complete.

End the pairing process

3 Sec

AUTO

OFF

MANUAL

TEST / PAIRING

+Hr

SELECT SET

TEST / PAIRING

+Hr

SELECT SET

Test the pairing process

If you bought an RXRT510 or RT510TX and intend pairing with other

devices in the 5x5 range, please refer to the Receiver Units manual, or the

relevant manuals available at www.salus-manuals.com

Button Description for RXRT510 Receiver

Button Function

ON The receiver is enabled, ready for use.

OFF The receiver is disabled, will not function.

AUTO The receiver will switch on and o automatically,

as operated by the thermostat.

MANUAL Providing ON is selected,the receiver will switch

on continuously, overriding the thermostat.

Button Description for RXBC605 Boiler Controller

Button Function

SYNC The boiler controller will be syncronised with the

thermostat.

AUTO The receiver will switch on and o automatically,

as operated by the thermostat.

MANUAL Select in the event of thermostat failure to switch

boiler on continuously, overriding the thermostat.

AUTO

OFF

MANUAL

Installation

RT510 Thermostat

Insert the batteries and

wire up the device.

Terminal Description Backplate

Common Terminal

1 (COM)

2 (NC)

Switched Live OFF

3 (NO)

Switched Live ON

Technical Support

T: 44 (0) 1226 323961

E: tech@salus-tech.com

Installation

RT510RF (RT510TX+RXRT510)Thermostat and Receiver

1. Wire up the receiver and switch the power on

2. Once the receiver is switched on then insert the batteries into the

thermostat. If using RT510RF pack the devices are already paired.

Now follow Test pairing process to conﬁrm connection between both the

thermostat and receiver. If purchased the devices separately please follow

pairing process.

TEST / PAIRING

SELECT

+Hr

SET

AUTO

ON OFF

MANUAL

868.0-868.6MHz; <13dBm

06/2017

+Hr

RESET

SELECT SET

After power up, the

receiver will be in

pairing mode and

the LED will ﬂash red.

Salus RXRT510 Anleitung

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Salus RXRT510

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info