Bedienungsanleitung Samson Concert 77 (Seite 5 von 47) (Deutsch, Englisch, Französisch, Spanisch)

623980

Zoom out

Zoom in

Vorherige Seite

1/47

Nächste Seite

ENGLISH

Guided Tour - CR77 Front Panel

1: Antennas (A and B)

- The antenna mountings allow full rotation for optimum placement. In

normal operation, both Antenna A (the antenna on the left) and Antenna B (the antenna on the

right) should be placed in a vertical position. Both antennas can be folded inward for conve-

nience when transporting the CR77. See the “Setting Up and Using the AirLine System” section

on page 17 in this manual for information about antenna installation and positioning.

2: Volume control

- This knob sets the level of the audio signal being output through both the

balanced and unbalanced output jacks on the rear panel (see #2 and #4 on page 8 in this manu-

al). Reference level is obtained when the knob is turned fully clockwise (to its “10” setting).

3: Audio Meter

- This “ladder” display (similar to the VU bar meter used on audio devices) indi-

cates the strength of the incoming audio signal. When the “0” segment is lit, the incoming signal

is optimized at unity gain; when the “+6” segment is lit, the signal is overloading. When only

the left-most “-20” segment is lit, the incoming signal is at just 10% of optimum strength. If no

segments are lit, little or no signal is being received. See the “Setting Up and the Concert Series

System” section on page 16 in this manual for more information.

4: Squelch control

- This control determines the maximum range of the CR77 before audio

signal dropout. Although it can be adjusted using the supplied plastic screwdriver, it should

normally be left at its factory setting. See the “Setting Up and Using the Concert Series System”

section on page 17 in this manual for more information.

5: A/B Antenna LEDs

- When signal is being received, one of these will be lit green, showing

you whether the (left) “A” or (right) “B” antenna is currently being used. The CR77 constantly

scans its two antennas and automatically selects whichever is receiving the strongest, clearest

signal. This

True Diversity

switching is completely inaudible, but it effectively increases overall

range while virtually eliminating potential interference and phase cancellation problems.

6: RF (Radio Frequency) Level meter

- This “ladder” display (similar to the VU bar meter used

on audio devices) indicates the strength of the incoming radio signal. When the “100%” segment

is lit, the incoming RF signal is fully modulated and at optimum strength. When only the second

most left-most “10%” segment is lit, the incoming signal is at just 10% of optimum strength.

If no segments are lit, little or no signal is being received. See the “Setting Up and Using the

Concert Series System” section on page 17 in this manual for more information.

7: Power switch

- Use this to turn the CR77 power on and off. When the receiver is on, the inter-

nal Power LED is lit.











       

 









Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Samson Concert 77 Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info