Bedienungsanleitung Samson Concert 77 (Seite 11 von 47) (Deutsch, Englisch, Französisch, Spanisch)

623980

Zoom out

Zoom in

Vorherige Seite

1/47

Nächste Seite

ENGLISH

Setting Up and Using the

Concert Series System

this is unity gain. If you are using the HT7 transmitter or if you are using the CT7 transmitter with

a connected lavalier microphone or headset, speak or sing into the mic at a normal performance

level while slowly raising the volume of your amplifier/mixer until the desired level is reached. If

you are using the CT7 transmitter with a connected instrument, play the instrument at normal

performance level while slowly raising the volume of your amplifier/mixer until the desired level

is reached. If you are using a CT7 beltpack transmitter equipped with a lavalier microphone, note

that correct lavalier placement is critical to sound quality. We recommend that you place it as

shown in the illustration on the right—as close to your

mouth as possible but off to one side (to minimize nasal-

ity) and unobstructed by clothing. Bear in mind also that

omni microphones (mics which pick up signal from all

directions) are more prone to feedback problems than

unidirectional (cardioid or supercardioid) ones; in gen-

eral, you can avoid feedback by taking care not to use

any microphone directly in front of a PA speaker (if this

is unavoidable, try using an equalizer to attenuate those

high- or mid-range frequencies which are causing the

feedback “squealing”).

10. If you hear distortion at the desired volume level, first

check to see whether the yellow “Peak” LED on the CR77

is lit. If it is not, make sure that the gain structure of your

audio system is correctly set (consult the owners manual

of your mixer and/or amplifier for details). If the yellow

“Peak” LED is lit, do the following:

• If you are using a HT7 transmitter, use the supplied plastic screwdriver to turn its

Microphone Input Level control (trimpot) slowly counterclockwise (towards the “Min” posi-

tion) until the distortion disappears.

• If you are using a CT7 transmitter with connected lavalier microphone or headset, its Audio

Input Level control has been factory preset to provide optimum level for the particular

lavalier or headset model being used and so no adjustment should be necessary. Any dis-

tortion present should therefore simply be a matter of the microphone being too close to

the mouth; try moving it further away. If this does not solve the problem, use the supplied

plastic screwdriver to turn the Audio Input Level control (trimpot) on the CT7 slowly coun-

terclockwise until the distortion disappears.

• If you are using a CT7 transmitter with an instrument such as electric guitar or bass, lower

the output level of the instrument until the distortion disappears. Alternatively, you can use

the supplied plastic screwdriver to turn the Level control (trimpot) on the CT7 slowly coun-

terclockwise until the distortion disappears.

Note that, following this setup procedure, you can always lower the Volume knob of the CR77 in

order to attenuate the output signal if necessary.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Samson Concert 77 Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info