Bedienungsanleitung Samson L2000 (Seite 16 von 24) (Englisch)

624005

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

Master Input and Output Section

The L1200 and L2000 mixer's Master Input and

Output section has the connectors for interfacing

the FOOTSWITCH, MAIN OUT, MAIN 2 OUT, MAIN

INSERT POINTS, GROUP OUTS, GROUP INSERT

POINTS, and the AUX Send’s.

6 - AUX SEND (1 through 3) - 1/4-inch jacks

The signals present at the AUX outputs are sent from

the AUX bus 1, 2 and 3, which are fed from the input

channels’ AUX 1, 2 and 3 control knobs. In a live

sound situation, AUX 1, 2 and 3 are normally used to

create three individual monitor mixes by connecting

the AUX output to a power amp and monitor

speaker. TS phone jack connector pin-out - Sleeve:

Ground, Tip: Hot (+).

7 - EFX SEND - 1/4-inch jack

The EFX SEND output is used to send a signal to

an external signal processor such as a delay or

reverb. The signal present at the EFX SEND output

is sent from the EFX bus, which is fed from the

input channels’ EFX control knob. TRS phone jack

connector pin-out - Sleeve: Ground, Tip: Hot (+),

Ring: Cold (-)

8 - CD/TAPE Inputs - RCA jacks

The L Series mixers feature a stereo line level input

on RCA connectors for connecting the output of

devices such as MP3, CD, computer soundcard,

cassette player, or any other line level device. These

are controlled by the CD/Tape level control.

9 - Record Out - RCA jacks

The signal present at this connector is the MAIN bus

signal before it has passed through the MASTER

level control. The nominal output level is -10dBV and

the impedance is 100 Ohms.

10 – STEREO RETURN

The L1200 and L2000 have one pair of 1/4-inch jacks

for connecting stereo line level sources like those

from the outputs of effects processors. The LINE

inputs have a nominal operating level of -40dBV

through - 10dBV. TRS phone jack connector pin-out

- Sleeve: Ground, Tip: Hot (+), Ring: Cold (-)

11 - MAIN 2 OUT - 1/4-inch jacks

In a live sound application, you can drive a second

speaker system using the MAIN 2 OUT outputs con-

nected to a power amplifier or powered speakers. In

a recording application, the MAIN 2 OUT outputs are

used to connect to a stereo device such as computer

sound card, MP3, or cassette recorder. The signal at

the MAIN 2 OUT jacks follows the MAIN 2 level con-

trol knob allowing you to set a different level to the

recorder. TR phone jack connector pin-out - Sleeve:

Ground, Tip: Hot (+).

12 - GROUP OUT - 1/4" jacks

In a live sound application, you can connect

additional zone speaker systems using GROUP OUT

outputs connected to a power amplifier or powered

speakers. The signal at the GROUP OUT jacks follows

the GROUP volume fader.TRS phone jack connector

pin-out - Sleeve: Ground, Tip: Hot (+), Ring: Cold (-)

L1200 and L2000 Input and Output Connections

1213

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Samson L2000 Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Samson L2000

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info