Bedienungsanleitung Samson MDR1248 (Seite 21 von 28) (Englisch)

23499

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

Operating the MDR1248 and MDR1688

SENDING AN INDEPENDENT MIX TO THE

MONITOR SPEAKERS

The MDR1248 and MDR1688’s AUX1 auxiliary send can be

used to feed a separate set of amplifiers and loudspeakers

for stage monitors. This lets you build one mono mix for

the amplifiers and monitor speakers facing the musicians,

and the other stereo mix for the amplifiers and speakers

facing the audience.

1. Connect the AUX1 output to your monitor's power

amplifier or powered monitor.

2. Press the input channels’ AUX 1 PRE/POST switches

in, to set AUX 1 up as a pre-fader bus.

3. Raise the AUX SEND 1 control knob, located in the

Master section, up to a little past “5” or halfway.

4. Raise the AUX 1 controls for the channels that you

wish to hear from the monitor speakers.

NOTE: When the AUX1 PRE/POST switch is pressed in and

set to “PRE”, the AUX 1 controls are "PRE-FADER SENDS"

which means they are not affected by the level settings

of each channel. This allows you to create a mix for the

monitor system that is independent of the main LEFT and

RIGHT MIX.

5. If feedback occurs, turn down the AUX SEND 1 knob

to lower the overall level sending to the monitor.

Then check the AUX1 levels of the individual chan-

nels to see if you need to turn one or more channels

down. Then try to raise the AUX 1 SEND level again.

NOTE: Adjusting the balance between the channel AUX1

control knobs and the AUX SEND 1 is a tricky but neces-

sary part of getting good levels in the monitor system. In

general, try to keep the master AUX SEND 1 higher than

the channel AUX1 levels to achieve a cleaner mix. In order

to get the most gain from your monitor mix, use an exter-

nal graphic equalizer (like a Samson S curve 131or D2500

digital EQ with feedback control) to cut out any frequen-

cies that cause feedback.

6. If you want to add effects from the internal effect

processor, or the effects from an external proces-

sor connected to the AUX RETURN 2 inputs, engage

the AUX RETURN 2 TO AUX 1 switch, located in the

Master section, by pressing it in.

USING THE CHANNEL INSERT JACKS

To further control your signal, channels 1-4 on the

MDR1248 and 1-8 on the MDR1688 feature an inser-

tion point, or “effects loop”, on one 1/4-inch phone jack,

INSERT SEND and RETURN. An insertion point is a patch-

point that interrupts the signal, allowing you to bring that

signal outside to be processed by another device. You

can use these connections to interface an external signal

processor like an equalizer, compressor, noise gate, reverb

and other audio devices. A common application for the

MDR1248 and MDR1688’s insert point is using a compres-

sor.

To send a signal to an external processor, use a standard

1/4-inch “Y” insert cable to connect the MDR1248 and

MDR1688 channel insert point. Connect the TRS (TIP /

RING / SLEEVE) plug to the channel INSERT point, and

then, connect the 1/4-inch (TIP / SLEEVE), INSERT SEND

plug to the input of the external processor. The signal is

sent back to the MDR1248 or MDR1688, using the 1/4-

inch (TIP / SLEEVE), INSERT RETURN plug connected to the

output of the external processor.

The diagram below shows a typical application for using a

compressor (in this example a Samson C com opti) in the

MDR1248 or MDR1688’s insertion point.

Below, is a diagram showing the wire for the TRS ‘Y” Insert

cable.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Samson MDR1248 Seite 21

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Samson MDR1248

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info