Bedienungsanleitung Samson SX2800 (Seite 8 von 60) (Deutsch, Englisch, Französisch, Italienisch, Spanisch)

629807

Zoom out

Zoom in

Vorherige Seite

1/60

Nächste Seite

Guided Tour - Rear Panel

1: Fan - This variable-speed fan provides vital cooling to your SX Series (the hotter the amp gets, the faster the fan blows!). Make

sure that both the front and rear panels are kept free of all obstructions and that cool, fresh air is accessible at all times. Also, try

to ensure that the SX Series is used in a dust-free environment.

2: Input connectors - Connect incoming signals to these electronically balanced Combination connectors, using either XLR or

1/4" TRS (Tip/Ring/Sleeve) plugs, wired as follows: Pin 2 (or Tip) hot, Pin 3 (or Ring) cold, and Pin 1 (or Sleeve) ground. We recom

mend the use of balanced three-conductor cabling wherever possible (unbalanced two-conductor 1/4" plugs can also be insert

ed into these inputs, but you’ll get better signal quality and less outside noise and hum if you use balanced lines). The SX Series

accepts input levels of any strength but needs at least +4 dBu to achieve maximum power. Stereo signals should be connected

to both the Channel 1 and Channel 2 input jacks; however, when operating the SX Series in Bridge or Parallel modes, use the

Channel 1 input jack only. See page 8 in this manual for more information about Parallel mode and pages 9 and 10 in this manual

for full interconnection instructions.

3: 5-way Binding Post - Use these to connect each channel of the SX Series to 4-ohm or 8-ohm loudspeakers. Be sure to con

nect the loudspeaker correctly, with the red (+) terminal normally connected to the positive input of the speaker and the black

(ground) terminal normally connected to the negative input of the speaker. See page 8 in this manual for more information

about Bridge mode and pages 9 and 10 in this manual for full speaker connection instructions.

4: Speakon™ output connectors - Alternatively, you can use these to connect each channel of the SX Series to 4- or 4-ohm

loudspeakers. See page 8 in this manual for more information about Bridge mode and pages 9 and 10 in this manual for full

Speakon™ connector wiring and interconnection instructions.

5: Circuit Breaker - This circuit breaker will trip if there is a fault with the mains voltage or if maximum output is exceeded (very

highly distorted). Push it in (once only!) to restart the amplifier after a short rest period.

6: Bridge / Stereo / Parallel switch - For normal operation, place this three-way switch in its center (“STEREO”) position. When

placed in its right (“PARALLEL”) position, the signal arriving at the Channel 1 input only is routed to the power amplifiers of both

Channel 1 and Channel 2 (the Channel 2 input is ignored). When placed in its left (“BRIDGE”) position, the signal arriving at the

Channel 1 input only is again routed to both power amplifiers (again, the Channel 2 input is ignored), but the two power ampli

fiers are bridged together. For more information, see the “Bridge and Parallel Modes” section on page 8 in this manual and the “SX

Series Connections” section on pages 9 -10 in this manual. WARNING: Due to the extremely high power output of the SX Series

when used in Bridge mode, be sure to use only loudspeakers sufficiently rated to handle the resultant wattage (in Bridge mode,

these must be 4 or 8-ohm speakers).

7: AC input - Connect the supplied heavy-gauge 3-pin “IEC” power cable here.









 

 

 

 





    







ENGLISH

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Samson SX2800 Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info