Bedienungsanleitung Samsung AR09FSFP Series (Seite 38 von 47) (Englisch)

684516

Zoom out

Zoom in

Vorherige Seite

1/47

Nächste Seite

Installing and connecting the drain hose of the outdoor unit

Frame

Ground

Estimated

snow fall

Snow-proof hood

Bottom surface of outdoor unit

Drain hose

Drain hole

Drain plug

While heating, ice may accumulate. During the process of defrosting, check if condensation draining is adequate. For adequate

draining, do the following:

The outdoor unit is loaded with sucient R-410A refrigerant. Do not vent R-410A into atmosphere: it is a uorinated

greenhouse gas, covered by Kyoto Protocol, with a Global Warming Potential (GWP) = 1975.

You should purge the air in the indoor unit and in the pipe. If air remains in the refrigerant pipes, it aects the compressor.

It may cause reduction of cooling capacity and malfunction. Refrigerant for air purging is not charged in the outdoor unit.

Use Vacuum Pump as seen in the picture.

1. Insert the drain plug into the drain hole on the underside of the outdoor unit.

1. Connect each assembly pipe to the appropriate valve on the outdoor unit

and tighten the are nut.

2. Tighten the are nut rst with your hands, and then with a torque wrench,

applying the following torque:

2. Connect a drain hose to the drain plug.

3. Ensure that condensation draining is adequate.

Drain hole

Drain plug

• Toavoiddrainplugfromcontactingtheground,securegapbetweenthe

ground and the bottom surface of the outdoor unit.

• Inareaswithheavysnowfall,piledsnowcouldblocktheairintake.

To avoid this incident, install a frame that is higher than estimated snow

fall. In addition, install a snow-proof hood to avoid snow from piling on the

outdoor unit.

• Wheninstalling,makesurethereisnoleakage.Whenrecoveringtherefrigerant,groundthecompressorrst

before removing the connection pipe. If the refrigerant pipe is not properly connected and the compressor works

with the service valve open, the pipe inhales the air and it makes the pressure inside of the refrigerant cycle

abnormally high. It may cause explosion and injury.

Purging the connected pipes

Outdoor unit Indoor unit

Gas pipe side

Liquid pipe side

Outer Diameter Torque (kgf•cm)

ø6.35 mm 140~170

ø9.52 mm 250~280

ø12.70 mm 380~420

ø15.88 mm 440~480

ø19.05 mm 990~1210

ø22.23 mm 990~1210

• Excessivetorquecanbecauseofgasleakage.

• Maketheelectricalconnectionandleavethesysteminto“standby

mode”.Donotturnonthesystem!

This is necessary for better vacuum operation (full OPEN position of

Electronic Expansion Valve - EEV -).

If using a multi system, install as described in the installation manual supplied with the outdoor unit.

Maldives ET_AR09FSFP@_IBIM_DB68-03376A_EN_2.indd 38 2012-12-3 18:55:02

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Samsung AR09FSFP Series Seite 38

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info