Bedienungsanleitung Samsung DTBS500F (Seite 14 von 15) (Englisch)

29555

Zoom out

Zoom in

Vorherige Seite

1/15

Nächste Seite

DTB-S500F

TROUBLESHOOTINGS

GB-27GB-26

Digital Terrestrial Receiver

Power supply

Type : SMPS

Input voltage :

AC 100-240V~, 50/60Hz

Fuse rating : 250V T1.6AH

Demodulator

DEMODULATION : OFDM DEMODULATION (DVB-T)

MODE : 2K/8K

CODE RATE : Viterbi Convolutional

Code Rate - 1/2,2/3,3/4,5/6,7/8

Tuner

Freq. Range : 50~860 MHz

Input signal level : -20 ~ -78 dBm

Channel selection : PLL frequency synthesizer

Input impedance : 75 Ω unbalanced

Connector type : Din type female(RF in/RF out)

Video decoder

System decoding : MPEG 2 ISO/IEC 13818

(Transport Stream)

Profile and level : MPEG 2 MP@ML (4:2:2)

Data rate : 1~ 15 Mb/s

Video formats : 4:3 (normal) & 16:9 (widescreen)

Picture resolution : 720(H) x 576(V) x 50 fields/sec

Audio Decoder

System decoding : MPEG 1 ISO/IEC 11172~3 layer I & II

Audio mode : single channel, dual channel, stereo,

joint stereo

Sampling frequency : 32, 44.1, 48, 96 KHz

NNoottee : The specification of the STB may be changed without notice in advance.

Problem Possible cause Solution of the problem

No display LED on Power cord Power cord plug in correctly

the front panel; not plugged in correctly

No power supply

No pictures on the screen Receiver in Standby mode; Set receiver to “On”;

Scart not connected tightly Check connection and correct;

to video output of television;

incorrect channel or video Check channel and video output and

output selected on television correct (TV instruction manual)

No sound Audio cord connected Check connection and correct;

incorrectly;

Loudness level = 0; Increase loudness on television set;

Muting active Press the MUTE key

Remote Control does not Incorrect operation; Point remote control

operate directly towards the Receiver.

Batteries dead or inserted Replace batteries or insert correctly

incorrectly

Poor picture quality Signal strength too low Check the signal strength in

the “Installation” menu, correct

alignment of your antenna

On-Screen Error Message Antenna cable not connected Check connection and correct;

“Searching for signal” or not tight;

incorrect position of the Check position and correct,

antenna; Check the signal strength in

the “Installation” menu

On-Screen Error Message Receiver not yet set Scanning of in “Installation” menu

“Channel data does not

exist.”

The device, packaging material (e.g. Styrofoam) and the batteries must never be

disposed of with household refuse. Please obtain appropriate information about the

regulations in your community, and dispose of all refuse in accordance with regulations

at the separate locations provided.

In some region, the digital terrestrial signal may be weak.

So you’d better use the antenna in which the booster was built, for watching the

weak signal channels.

You can download and upgrade the system software of the receiver through

a specific channel through a specific channel designated by the broadcaster.

The Distributor will provide you with more information about that.

DISPOSAL

TECHNICAL SPECIFICATIONS

DTB-S500F GB_1004 10/4/04 5:28 PM Page 26

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Samsung DTBS500F Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Samsung DTBS500F

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info