Bedienungsanleitung Samsung DW60J9960 (Seite 13 von 160) (Deutsch, Englisch, Holländisch, Französisch)

580821

Zoom out

Zoom in

Vorherige Seite

1/160

Nächste Seite

English - 13

02 SETTING UP

Sanitize

With the Sanitize option selected, the water temperature is increased to 70˚C

for high temperature sanitization.

You cannot select the Sanitize option if you select the Delicate cycle.

Dry+ (Child Lock)

Use this option when you want to dry your dishes more completely.

The temperature rises to 65˚C in the ﬁ nal rinse cycle and dry time is increased.

If you select the this option, electricity consumption is increased.

*Child Lock : This option allows you to lock the buttons on the control panel -

except the Power button - so children cannot accidently start the dishwasher

by pressing the buttons on the panel. Only the Power button remains active.

To lock or unlock the buttons on the control panel, press and hold the Dry+

(Child Lock) button for three (3) seconds.

• When the Power is On : Press and hold the “Dry+ (Child Lock)” button for

three (3)seconds.

• When the Power is O : Push the Power button ﬁ rst, and then press and

hold the “Dry+ (Child Lock)” button for three (3) seconds.

• Child Lock remains active until you turn it o . You cannot select cycles or

options or start the dishwasher when Child Lock is on.

Display

Displays cycle time and remaining hours and minutes, Delay Start hours, and

check messages.

If an problem occurs during an operation, an check message is displayed with

a warning sound.

Refer to the “Troubleshooting and information codes” section on page 32.

Child Lock indicator

Turns on if the Child Lock is set (or the dishwasher is in the standby or

pause modes).

- Turns o while the dishwasher is operating.

- When Child Lock is on, the Child Lock indicator blinks for several

seconds if any button except the Power button is pressed.

Self Clean indicator

- Turns on when the Self Clean option is enabled (or the dishwasher is

in the standby or pause modes), but turns o while the dishwasher is

operating.

- Blinks for 5 seconds every 20 to 22 cycles.

- The cycle counter disappears when the Self Clean operation is complete

or when the dishwasher reaches the 23rd cycle without the Self Clean

cycle being used. (The Reset or Self Clean operation is not counted by

the cycle counter.)

Rinse Reﬁ ll indicator

- Turns on if the dishwasher runs out of rinse aid (or the dishwasher is in

the standby or pause modes).

- Turns o while the dishwasher is operating.

Lack of salt indicator (*applicable models only)

- Tu

rns on when the water softener runs out of salt. (or the dishwasher is

in the standby or pause modes.)

- Turns o while the dishwasher is operating.

User Manual_DW9000H-Series-00156A-04_EN.indd 13User Manual_DW9000H-Series-00156A-04_EN.indd 13 2015-03-24  5:18:222015-03-24  5:18:22

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Samsung DW60J9960 Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info