Bedienungsanleitung Samsung HG65NC890 (Seite 23 von 54) (Englisch)

686777

Zoom out

Zoom in

Vorherige Seite

1/54

Nächste Seite

English

y RJP (Remote Jack Pack): The RJP is a hardware module that has various Audio and Video inputs (A/V Video, A/V Audio,

PC and HDMI) and corresponding outputs. The corresponding outputs are connected from the RJP to the TV. The RJP

communicates with the TV via RS232. The RJP communicates with the TV by sending messages regarding Active/Inactive

sources.

– A group of hotel menu items let you assign numbered priorities to the jacks of the RJP. (See page 26). 1 is the highest

priority and 3 is the lowest. When a guest connects external sources to the RJP jacks, the TV will automatically switch

between sources based on the priority you have assigned them in the Menu. For example, lets say AV is set to 1

and HDMI to 2. If a guest has attached a device to the HDMI jack, and then plugs a device into the AV jack, the TV

automatically switches to the device plugged into the AV jack (the jack with the higher priority). Note that a guest can

also switch between devices manually by pushing a button on the RJP.

y To reset the RJP to its factory default state, press the AV and HDMI buttons simultaneously for 10 seconds. When all

button LEDs blink 5 times, the RJP reset is complete.

y The RJP will automatically turn off any LEDs after 5 minutes to avoid unnecessary light pollution in the hotel room. The

LEDs that were turned off will turn on again if the guest touches any of the buttons and the 5 minute timer will restart. If the

guest then touches another source button, the TV will change to the selected source and the corresponding LED will be lit.

y After an RJP Reset or a TV Power OFF/ON, it takes approximately 10 seconds to establish communications between the

TV and the RJP.

y The following table shows the approximate time in seconds it takes to switch from the TV to an input source, based on

assigned or default priorities.

✎

Scenario 1 : When no inputs are connected.

Source To Connect

AV 2 Sec

PC 0.7 Sec

HDMI 3.9 Sec

✎

Scenario 2: When two or more inputs are connected to the RJP and one of the input sources is disconnected and

then reconnected.

Source Disconnect To Connect Total

AV 4.5 Sec 2 Sec 6.5 Sec

PC 0.7 Sec 0.7 Sec 1.4 Sec

HDMI 3.9 Sec 3.9 Sec 7.8 Sec

✎

An example: If the RJP has all its live sources (AV, PC, and HDMI) connected, AV has been assigned the highest

priority, the RJP is in HDMI mode, and a guest removes and reconnects the AV source, the minimum time required

to switch to the AV source is 6.5 seconds.

y To play audio devices (Ipods, MP3 devices, etc.) through the RJP, you must turn Music Mode AV in the menu on. (See

page 26)

y Music mode in the TA-7610 RJP is supported by the AV jack only. HDMI Music mode is available for the Guestlink RJP

only.

[HC890_ZA]Install_Guide_00ENG.indd 23 2014-04-02  1:39:20

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Samsung HG65NC890 Seite 23

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info