Bedienungsanleitung Samsung HT-H7500WM (Seite 12 von 260) (Deutsch, Englisch, Holländisch, Französisch)

576271

Zoom out

Zoom in

Vorherige Seite

1/260

Nächste Seite

12 - English

Connections

✎

If you place a speaker near your TV set, the screen colour may be distorted because of the magnetic field.

✎

Place the wireless receiver module at the rear of the listening position. If the wireless receiver module is too

close to the product, sound from the speakers may be disrupted because of interference.

✎

If you use a device such as a microwave oven, wireless LAN Card, Bluetooth device, or any other device

that uses the 2.4/5.8GHz frequencies near the product, sound from the speakers may be disrupted because

of interference.

✎

The maximum transmission distance from the product to the wireless receiver module is about 10m, but

may vary depending on your operating environment. If a steel-concrete wall or metallic wall is between the

product and the wireless receiver module, the system may not operate at all, because the radio waves

cannot penetrate metal.

✎

If the product doesn't make a wireless connection, you need to run an ID Set between the product and

wireless receiver module. With the product turned off, press and hold

(mute) button on the remote control

for 5 seconds. Turn on the wireless receiver module. Then, press and hold the "ID SET" button on the back

of the wireless receiver module for 5 seconds, and then turn the product on.

| CAUTION |

If you want to install the speakers on the wall, fasten screws or nails (not provided) firmly to the wall wherever

you want to hang a speaker, and then, using the hole in the rear of each speaker, carefully hang each

speaker on a screw or nail.

Do not let children play with or near the speakers. They could get hurt if a speaker falls.

When connecting the speaker wires to the speakers, make sure that the polarity (+/ –) is correct.

Keep the subwoofer speaker out of reach of children to prevent children from inserting their hands or alien

substances into the duct (hole) of the subwoofer speaker.

Do not hang the subwoofer on the wall using the duct (hole).

The wireless receiving antenna is built into the wireless receiver module. Keep it away from water and

moisture.

For optimal listening performance, make sure that the area around the wireless receiver module location is

clear of any obstructions.

In 2-CH mode, you will hear no sound from the wireless surround speakers.

Attaching the Toroidal Ferrite Core to the Power Cord of the Wireless

Receiver Module (SWA-6000)

If you attach a Toroidal ferrite core to the power cord of the wireless

receiver module, it will help prevent RF interference from radio signals.

1. Pull the fixing tab of the Toroidal ferrite core to open it.

2. Make two loops in the wireless receiver module power cord.

3. Attach the Toroidal ferrite core to the wireless receiver module's

power cord as shown in the figure on the right, and then close it

by pressing it until it clicks.

• Attach the ferrite core as close to the Wireless Receiver Module

as possible.

HT-H7500WM_7750WM-XU-0515.indd 12HT-H7500WM_7750WM-XU-0515.indd 12 2014-05-19  1:31:352014-05-19  1:31:35

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Samsung HT-H7500WM Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info