Bedienungsanleitung Samsung LE52B620 (Seite 48 von 458) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch, Türkisch)

465954

Zoom out

Zoom in

Vorherige Seite

1/458

Nächste Seite

English - 46

Issue Solution

Others

Picture is not shown in full screen. Black bars on each side will be shown on HD channels when displaying upscaled SD

(4:3) contents.

Black bars on Top & Bottom will be shown on movies that have aspect ratios different

from your TV.

Adjust picture size option on your external device or TV to full screen.

●

Remote control does not work. Replace the remote control batteries with correct polarity (+ -).

Clean the transmission window located on the top of the remote.

Try pointing the remote directly at the TV from 5~6 feet away.

●

Can not control TV power or

volume with Cable/Set top box

remote control.

Programme the Cable/Set top box remote control to operate the TV. Refer to Cable/Sat

user manual for SAMSUNG TV code.

●

‘Not Supported Mode’ message. Check the supported resolution of the TV and adjust the external device’s output

resolution accordingly. Refer to resolution settings in this manual.

●

Plastic smell from TV. This smell is normal and will dissipate over time.

●

TV Signal Information is

unavailable in the Self Diagnostic

Test menu.

This function is only available with digital channels with an Antenna (RF/Coax)

connection.

●

TV is tilted to right or left side. Remove the stand base from TV and reassemble.

●

Can not assemble stand base. Make sure TV is placed on flat surface. If can not remove screws from TV, please use

magnetized screw driver.

●

Channel menu is grey out.

(unavailable)

Channel menu is only available when TV source is selected.

●

Your settings are lost after 30

minutes or every time TV is

turned off.

If TV is in the Store Demo mode, it will reset audio and picture settings every 30

minutes. Please change from Store Demo mode to Home Use mode in the

Plug & Play procedure. Press the SOURCE button to select TV mode, go to MENU →

Setup → Plug & Play → ENTER

●

Intermittent loss of audio or video. Check cable connections and reconnect.

Can be caused by using overly rigid or thick cables. Make sure the cables are flexible

enough for long term use. If wall mounting, we recommend using cables with 90

degree connectors.

●

You may see small particles if you

look closely at the edge of the

bezel surrounding the TV screen.

This is part of the product’s design and is not a defect.

●

‘Scramble signal’ or ‘Weak

Signal/No Signal’ with CAM

CARD(CI/CI+).

Check that CAM has CI(CI+) Card installed into the common interface slot.

Pull out CAM from the TV and insert into the slot again.

●

When turned off and 45 minutes

later, TV is turned on itself.

It is normal, the TV operate OTA (Over The Air) function itself to upgrade firmware

downloaded during watching.

●

Recurrent picture/sound issue. Check and change signal/source.

●

This TFT LCD panel uses a panel consisting of sub pixels which require sophisticated technology to produce. However, there

may be few bright or dark pixels on the screen. These pixels will have no impact on the performance of the product.

[620-Weuro]BN68-02326A-03L09.ind46 46 2009-10-08 ¿ÀÀü 9:27:58

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Samsung LE52B620 Seite 48

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Samsung LE52B620

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info