Bedienungsanleitung Samsung ML-6510 (Seite 100 von 130) (Englisch)

586979

100

Zoom out

Zoom in

Vorherige Seite

1/130

Nächste Seite

Supplies and accessories_ 100

2. Pull the imaging unit out.

3. Remove the new imaging unit from its bag.

• Do not use sharp objects, such as a knife or scissors, to open

the toner cartridge package. They might scratch the drum of

the cartridge.

• To

prevent damage to the imaging unit, do not expose it to light

for more than a few minutes. Cover it with a piece of paper, if

necessary.

4. Thoroughly shake the imaging unit 5 or 6 ti

mes to distribute the toner

evenly inside the imaging unit.

5. Remove the protection cover and seal.

6. Hold the imaging unit by the handle and slowly insert the cartridge into

the opening in the machine.

Tabs on the sides of the imaging unit a

nd corresponding grooves within

the machine will guide the imaging unit into the correct position until it

locks into place completely.

• Do not touch the green surface of the imaging unit.

• To prevent damage to the imaging unit, d

o not expose it to light

for more than a few minutes. Cover it with a piece of paper, if

necessary.

7. Reinsert the toner cartridge.

8. Close the top cover. Make sure that the cover is securely closed.

NECESSARY PRECAUTIONS TO TAKE WHEN

INSTALLING ACCESSORIES

• Disconnect the power cord.

To avoid the possibility of an electrical shock, always disconnect the

wer cord when installing or removing ANY internal or external acces-

sories.

• Discharge static electricity.

he control board and internal accessories (network interface card or

memory modu

le) are sensitive to static electricity. Before installing or

removing any internal accessories, discharge static electricity from your

body by touching something metal, such as the metal back plate on any

device plugged into a grounded power source. If you walk around before

finishing the installation, repeat this procedure to discharge any static

electricity again.

• Activatin

g the added accessories in the PS driver properties.

After installing an accessory such as an optional tray, PS driver users

must do the additiona

l setting. Go to the PS printer properties and set

the added accessory activated.

When installing accessories, the battery inside the machine is a ser-

vice component and needs to be replaced by an authorized servicer.

not change it by yourself.

There is a risk of an explosion if battery is replaced by an incorrect

type.

ACTIVATING THE ADDED ACCESSORIES IN

PRINTER PROPERTIES

After installing added accessories, you need to select it in the printer proper-

ties of the printer driver in order to use it.

1. Install the driver (See "

Installing locally connected machine’s driver" on

page 32 or "Installing network connected machine’s driver" on page 38).

2. Click the

Windows St

art menu.

3. For Windows 2000, select Set

tings > Printers.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Samsung ML-6510 Seite 100

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Samsung ML-6510

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info