Bedienungsanleitung Samsung RL 34 EG (Seite 5 von 10) (Englisch)

72014

Zoom out

Zoom in

Vorherige Seite

1/10

Nächste Seite

1 .Take down the SCREW B which is fixing the COVER TOP

FRONT and then COVER TOP FRONT. Pull out the wire inserts.

Take down COVER HINGE UPP R and fridge door. Take downd and fix

SHAFT-HINGE to the opposite side of HINGE UPP. Take down

CAP HOLE TOP at COVER TOP FRONT and install it

on the right of COVER TOP FRONT.

2. Take down SCREW A, SCREW E and MID HINGE of the fixing hinge and then freezer door. Take

down CAP HINGE HOLE, CAP SCREW CABI and SCREW F at left and install them at right.

3. Gently incline the appliance in less than 45 degree, remove the right FOOT and unfasten SCREW

D. Take down right HINGE LOW. Then take down FIX HINGE LOW, and STOPPER

HINGE LOW. Reverse STOPPER HINGE LOW and fix it to the left of HINGE LOW with

FIXER HINGE LOW and .

4. Take down the left FOOT and unfasten SCREW D. Take down and fix REINF to the right. Then fix

FOOT.

5.Take off the SCREW G and STOPPERDOOR in the freezer door and install them at the left of the

door. Take off CAP HOLEDOOR, CAP SCREW HANDLE, SCREW C, HANDLE UPP, HANDLE BAR,

HANDLE LOW, CAP HANDLE, and CAP SPACER DOOR, and install them at the right of the door.

Install CAP HOLEDOOR on the left of the door.

6.Install the freezer's door, and fix MID HINGE with SCREW A and SCREW E. Fix the refrigerator's

door with SCREW A and HINGE UP L.

7.Fix the wire inserts properly. Install COVER HINGE UPP L and cover it with COVER DOOR UPP.

8.Install COVER TOP FRONT and finally fasten SCREW B.

SHIFT HINGE

Changing the direction of the door opening(RL34EG*)

Safety Precautions

When comparing the appliance with other refrigerators, please refer to the model and

number;

Before the appliance is connected to the power, verify if voltage rating of the refrigerator is

same to the power voltage. The voltage can be variable from 187V to 240V; if the power

voltage can not meet the requirements, an automatic transformer with a minimum output of

500W shall be used.

If the appliance is disconnected from the power, you should wait for at least five minutes

before reconnection; otherwise there may be a hazard to the compressor.

Do not store food close to the temperature sensor; otherwise it may display wrong

temperatures.

Do not open and close the door too frequently or for a long time during hot weather;

otherwise it may affect the efficiency of the entire unit and burden the appliance with

excessive load.

Do not leave the refrigerator upside down or horizontal or keep inclined over 45 degree to

the ground if necessary;

Do not pull or push the appliance by holding the door handles or exert too much upward/

downward forces on the door handle;

If a lot of hot foods are stored at the same time or the door is opened frequently or kept open

for a long period of time, the internal temperature will rise and the temperature display may

flash. It will be recovered normal after a period of stable operation;

The refrigerator must be located with an easy access to the power supply.

1.Remove all the packing materials of the components,

and do remove the foam pad under the refrigerator

during the operation;

2.Clean the interior and exterior of the refrigerator with

wet warm cloth (add little neutral detergent in the warm

water).

3.the power plug can be connected around one hour after the

refrigerator is positioned stable,please make the approciate

operations with careful reference to the page of control panel

introduction.

Preparing the appliance for use

Caution

The cooling effects originates from refrigerant that is filled through

special process. Please ensure the pipes in the rear are intact.

Alert

This appliance adopts R600a refrigerant which is combustible.

During transportation and installation, please handle the appliance carefully

to protect the cooling system from damage.

- To avoid the combustible gas composed of the refrigerant leaked from the cooling circuit and the air,

please select the room size to accommodate t he appliance according to the refrigerant quantity.

The room size shall be calculated as per the criterion of 8g R600a per square metres.

For details of the refrigerant quantity, please refer to the manual.

- Do not start the appliance that has any damage. If any problems, please contact the dealer or

service centre.

The refrigarant leaked from the pipe may catch fire or hurt your eyes. If refrigerant leakage occurs,

please keep away the fire or potential fire source, and keep the room aired for several minutes.

COVER TOP FRONT

CAP SCREW CABI

CAP HINGE HOLE

MID HINGE

REINF

SCREW D

FOOT

HINGE LOW

CAP HANDLE

SCREW A

HINGE UPP R

FOOT

SCREW B

CAP SPACER DOOR

COVER TOP UPP

CAP HOLE DOOR

STOPPER DOOR

CAP HOLE DOOR

STOPPER HINGE LOW

FIXER HINGE LOW

COVER HINGE UPP L

COVER HINGE UPP R

CAP SCREW HANDLE

SCREW A

SCREW E

SCREW C

CAP SCREW HANDLE

SCREW C

SCREW D

SCREW F

CAP SCREW CABI

CAP HINGE HOLE

SCREW F

SCREW G

SHAFT-HINGE

CAP HOLE TOP

SHAFT HINGE

Advance Type:

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Samsung RL 34 EG Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Samsung RL 34 EG

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info