Bedienungsanleitung Samsung syncmaster 711 mp (Seite 36 von 52) (Englisch)

142712

Zoom out

Zoom in

Vorherige Seite

1/52

Nächste Seite

Refer to Specifications > Preset Timing Modes for the resolutions or frequencies that are

supported by the monitor.

Contact the computer dealer or manufacturer for information on safe mode booting.

3. Display Adapter Driver

Display adapter refers to the computer video card driver.

If the adapter is not properly set, you cannot adjust resolution, frequency or color and you cannot

install the monitor driver.

1. Checking Adapter Driver

Click Start Settings Control Panel Display Settings Advanced

Adapter.

If "Default" or a wrong product model is indicated, it means that the adapter driver is not properly

installed. Install the adapter driver again according to the information provided by the computer or

video card manufacturers.

2. Installing Adapter Driver

The instructions given below are for general circumstances.

For specific issues, contact the relevant computer or video card manufacturers.

Click Start Settings Control Panel Display Settings Advanced

Adapter Update Driver Next Display a list of the known drivers for this device so

that I can choose a specific driver Next Have Disk (Insert Video Card Driver diskette)

OK Next Next Finish.

2) In case you have Adapter Driver Setup file on your computer:

Run Setup.exe or Install.exe, which is found in the Adapter Driver Setup file.

4. Maintenance and Cleaning

1. Maintaining the Monitor Case.

Clean with a soft cloth after disconnecting the power cord.

2. Maintaining the Flat Panel Display Screen.

Clean with a soft cloth (cotton flannel) smoothly.

Do not use benzene, thinner or other flammable substances, or a

wet cloth.

Never use acetone, benzene or thinner.

(They may cause flaws or deformation of the screen surface.)

We recommend a Samsung cleansing agent is used to prevent

damage to the screen.

The user will be required to pay costs and related expenses for

repair of damages caused by him/her.

5. Symptoms and Recommended Actions

A monitor recreates visual signals received from the computer. Therefore, if there is trouble with the

computer or the video card, this can cause the monitor to become blank, have poor coloring, noise,

unavailable video mode, etc. In this case, first check the source of the problem, and then contact the

service center or your dealer.

1. Check if the power cord and the video cables are properly connected to the computer.

2. Check if the computer beeps more than 3 times when booting.

(If it does, request an after-service for the main board of the computer.)

3. If you installed a new video card or if you assembled the PC, check if you installed the adapter(video)

driver and the monitor driver.

4. Check if the scanning ratio of the video screen is set at 60Hz.

(The screen refresh rate must be set within in a range of 56~75hz.)

5. If you have problems in installing the adapter (video) driver, boot the computer in Safe Mode, remove

the Display Adapter at the "Control Panel, System, Device Administrator" and then reboot the

computer to reinstall the adapter (video) driver.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Samsung syncmaster 711 mp Seite 36

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Samsung syncmaster 711 mp

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info