Bedienungsanleitung Samsung VR7MD97714 (Seite 7 von 58) (Englisch)

820837

Zoom out

Zoom in

Vorherige Seite

1/58

Nächste Seite

Safety information

Do not use the Jet Bot Combo on tables or other high surfaces.

• There is a risk of damage if it falls.

The Jet Bot Combo may bump into chairs or desk legs, therefore move them away for faster and efficient

cleaning.

When the Jet Bot Combo is operating, do not lift it up or carry it to another area.

Do not hold by Driving Wheels of the Jet Bot Combo when carrying it to another area.

Do not allow children to sit on the Jet Bot Combo and do not place an object on the Jet Bot Combo.

• It may cause malfunction of the LiDAR sensor and the Jet Bot Combo.

Remove any large papers or plastic bags immediately when using the Jet Bot Combo since they may block

the intake.

Do not lie down around the Jet Bot Combo that is running.

• Your hair may be caught in the brush, resulting in physical injury.

Do not allow children to play with the Jet Bot Combo.

Make sure hair, fingers, towels do not get caught in the Spin Brush, brush or the wheels of the Jet Bot

Combo.

Leave over 3 cm space from the inner doorstep placed in the entrance. The Jet Bot Combo may climb over

it.

Prevent any damage to the Jet Bot Combo by complying with the following.

• Do not clean the Jet Bot Combo by spraying water directly onto it or use a volatile substance such as

benzene, thinner, or alcohol to clean it.

Do not disassemble or repair the Jet Bot Combo. This should only be done by a certified repairman.

Do not store the Jet Bot Combo in a car.

Be careful that the LiDAR sensor is not exposed to a direct light such as sun light, infrared light, etc.

• The direct light can affect the performance of the LiDAR sensor.

When carrying the Jet Bot Combo, be careful not to let it drop.

• The impact from the drop can affect the operation or performance of the LiDAR sensor.

Remove objects that are 1 cm or less in height and light in weight before cleaning, as they can be caught

and get dragged around or be caught in the Jet Bot Combo’s brush or Driving Wheels while it is operating.

(Only compliant to model VR7MD97714*)

Remove objects that are 9 cm or less in height and light in weight before cleaning, as they can be

caught and get dragged around or be caught in the Jet Bot Combo’s brush or Driving Wheels while it is

operating. (Fixed objects are detected by pressure on the bumper and avoided.) (Only compliant to model

VR7MD96514*)

• However, obstacles in the front center that are more than 5 cm in height and less than 4 cm in width

are detected.

Entry under furniture lower than approximately 14 cm in height may be blocked as it may be detected as

an obstable.

If oil such as cooking oil is on the floor, the Jet Bot Combo may become stationary because the floor is

slippery. Remove the oil first before cleaning with the Jet Bot Combo.

Watch your hands while placing the Waste Water Tank and Clean Water Tank, since they may get stuck in

the Clean Station.

Do not drink the water from both Waste Water Tank and Clean Water Tank.

Be careful of the steam or high temperature water while Mops are being cleaned.

English 7

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Samsung VR7MD97714 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Samsung VR7MD97714

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info