Bedienungsanleitung Sangean RCR-11 (Seite 15 von 84) (Englisch)

797013

Zoom out

Zoom in

Vorherige Seite

1/84

Nächste Seite

The manually specied IP address should be chosen to be compatible with the settings in your

router and must be a unique address on your network. If you are using DHCP for some devi-

ces and static (manually congured) IP addresses for others, the IP address used should fall

outside the range that the router may allocate using DHCP. Typically, the rst three groups

of digits will be the same for all devices on your network. To enter the IP address, press the

Tuning buttons to set the value for each group of digits and then press the Select button to

enter the value and to move on to the next group. When the IP address has been entered, the

subnet mask should be entered. The subnet mask denes which parts of the IP address are

common across your network. For most small networks the subnet mask will be 255.255.255.0

and this is entered in the same way.

The Gateway address is normally the IP address of the router through which the radio

connects to the internet and is entered in the same way as the previous addresses.

In most installations the DNS settings (DNS = Domain Name Server) will be set to the same IP

address as your router. In this case the secondary DNS may be left at zero. To enter the DNS

address, press the Tuning buttons to set the value for each group of digits and then press the

Select button to enter the value and to move on to the next group. Repeat this until all eight

groups of digits have been entered.

The next step is to set up the WiFi connection, starting with the name of the wireless network

(SSID) followed by the encryption options and password. To enter the SSID, characters are se-

lected and entered using the Tuning buttons The radio scrolls through the available characters

as well as the three controls on the right. The character currently highlighted will be entered

when you press the Select button. Do this as needed until the complete network name has been

entered. The SSID setting is sensitive to upper and lower case characters and symbols.

You must enter it exactly as set up in your router. The three controls on the right-hand side of

the screen have special functions:

select ‘ ’ to erase a character just entered

select ‘ ’ when the complete SSID has been entered

select ‘ ’ to cancel and go back to the DNS settings screen

Having entered the SSID, you must enter details of the encryption system used on your wi-

reless network. This should be the same as specied in your router settings. If your network

does not use encryption, then select the ‘Open’ option. Your radio should then connect to the

network, so skip to step 11. If your network uses WEP (Wired Equivalent Privacy) select the

‘Pre-Shared Key’ option then go to step 8. The remaining options are for WPA or WPA2 (WiFi

Protected Access) – see step 9.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sangean RCR-11 Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Sangean RCR-11

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info