521323
14
Zoom out
Zoom in
Vorherige Seite
1/16
Nächste Seite
14
10 Troubleshooting
Problem/Question Possible Cause/Remedy
1. Too much or too little medicine in the atomiser.
Minimum: 0.5 ml, Maximum: 6 ml.
2. Check that the nozzles are not blocked
If necessary, clean the nozzle (e.g. by rinsing).
Use the atomiser again.
CAUTION: Only poke implements through the fine holes
from the underside of the nozzle.
3. The atomiser is not held in an upright position
The atomiser produces
little or no aerosol
4. The medicine solution is unsuitable for nebulising
(e.g. too thick).
The medicine solution should be specified by the doctor.
Output is too low Hose kinked, filter blocked, too much inhalation solution
Which medicines are
suitable for inhalation?
Consult your doctor.
Essentially all medicines that are suitable and approved for
device-based inhalation can be inhaled.
Some inhalation solu-
tion remains in the at-
omiser.
This is normal and occurs for technical reasons. Stop inhala-
tion if you hear a notable difference in the noise of the atom-
iser.
What special steps
should be taken for ba-
bies and children?
1. In babies, the mask should cover the mouth and nose to
guarantee effective inhalation.
2. In children, the mask should also cover the mouth and
nose. Nebulisation next to a sleeping person is not suit-
able because insufficient medicine reaches the lungs.
Note: Children should only use the device with help and under
supervision of an adult. Never leave a child alone with the
nebuliser.
Inhalation with the mask
takes longer
This is for technical reasons. Less medicine is inhaled per
breath through the mask holes than using the mouthpiece. The
aerosol is mixed with ambient air through the holes in the
mask.
Why do I need to re-
place the atomiser at
regular intervals?
There are two reasons for this:
1. To guarantee a therapeutically effective particle spectrum,
the nozzle holes should not exceed a certain diameter.
Due to the thermal and mechanical stresses, the plastic is
subjected to a certain amount of wear. The nozzle attach-
ment [10] is particularly susceptible to this wear. This can
also cause changes to the droplet composition of the
aerosol, which has a direct effect on the effectiveness of
the treatment.
2. You are also recommended to replace the atomiser on a
regular basis for hygiene reasons.
Does each person need
their own atomiser?
This is absolutely necessary for hygiene reasons.
14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

sanitas-sih20

Suche zurücksetzen

  • vernebler sprüht zu stark, kann man das regulieren? Wenn ja dann wie Eingereicht am 9-6-2018 17:03

    Antworten Frage melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Sanitas SIH20 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Sanitas SIH20

Sanitas SIH20 Bedienungsanleitung - Deutsch - 32 seiten

Sanitas SIH20 Bedienungsanleitung - Holländisch, Französisch - 32 seiten

Sanitas SIH20 Bedienungsanleitung - Italienisch - 32 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info